Eurozone inflation (HICP) is published first as a flash estimate at the start of the month and later as a final reading. The flash usually moves EUR; the final rarely does — with some exceptions.
Why the final usually matters little:
Revisions are typically small, often 0.0 or 0.1 percentage points.
Country data (Germany, France, Spain, Italy) already gives a good picture before the flash.
When the final can matter:
When the flash was close to a threshold that the market cares about, and a revision would cross it.
When the ECB is close to a decision and every detail counts.
When component details (services, core) are revised more than the headline.
A practical approach is to treat the final release as low impact by default, but check the size of the flash surprise and the ECB timeline before dismissing it.
Do you trade the flash HICP, and have you ever seen the final reading move EUR?
FXS Prop Desk, I trade the flash HICP when the surprise is clear and the ECB meeting is inside two weeks. The final reading is a skip by default unless the flash sat on a threshold the market was debating.
Revisions of 0.0 or 0.1 rarely move EUR enough after costs for a scalp. I still open the calendar, though, because component revisions in services have surprised me twice in the last year.
When the flash was soft by a tenth and the final nudged back toward consensus into an ECB week, I saw a short EUR fade worth about twelve pips before it died. That is rare enough that I size half if I take it at all.
Country prints ahead of the flash already do most of the work. By the time the final lands, my bias is usually set and I am not looking for a fresh ticket.
I treat the final as low impact unless ECB risk is high. Have you ever held a position into the final on purpose, or do you always flatten before it?
Before treating a 0.1 revision on the final as news, I check whether it is just rounding. A flash of 2.04 percent prints as 2.0 and a final of 2.05 prints as 2.1, so the headline moves a tenth while the real change is one hundredth.
Eurostat publishes the index levels, so I compute the unrounded annual rate for both releases myself. When the gap is under 0.03 points I ignore the revision, whatever the rounded figure says.
The opposite case is more useful. A flash of 1.96 that printed as 2.0 can be revised to 1.94 and print as 1.9, crossing a level the market quotes even though the change is tiny.
Timing matters on the day as well. The final sometimes lands close to US CPI, and when both fall on the same day I have stopped trying to read the euro reaction to the final at all.
That leaves very few clean final release days in a year for me. Do you look at the index levels, or only at the published one decimal figures?
A trader sits down at the London open with the eurozone flash PMI due in a few minutes. Spread looks normal, the pair is calm. The number lands and the euro jumps 25 pips in under a minute. An example, but a familiar one.
A few weeks later the final PMI for the same month arrives with almost the same figure. Nothing happens. A flat chart, and a trader who waited around for it.
Flash readings use an early sample of survey responses, usually around 85 to 90 percent of the final total. Final readings add the rest, and the revision is typically small. Markets price the surprise, and by the final release there's rarely any surprise left.
The exception is a large revision. A final number that differs noticeably from the flash can still move price, because it breaks what was already priced in. Those cases are rare, which is why most calendars treat the final as a footnote.
For scalpers the practical gap is simple: the flash release carries event risk, and the final mostly doesn't. Yet both often sit under the same impact colour on a calendar.
Which PMI release has given the cleanest reaction on your pairs, the flash or something else? And is any PMI worth trading at all?