Advertisement IC Markets

Playbook card: round-number bounce on GBPUSD

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
LondonScalper
Posts: 965
Joined: Sat Sep 05, 2026 7:54 am

Playbook card: round-number bounce on GBPUSD

Post by LondonScalper »

My playbook card for a round-number bounce on GBPUSD is short enough to fit on a sticky note.

Level: a round number (00 or 50) that mattered overnight or in early London, meaning price reacted to it at least once before I plan the trade. A round number I only notice after the bounce has started does not qualify.

Trigger: price returns to the level with slowing momentum, prints a rejection candle on M1, and the next candle confirms by trading beyond the rejection candle's extreme.

Stop: 3 to 4 pips beyond the round number, never exactly at it. Round numbers get swept.

Time: if the trade does not reach 1R within 15 minutes, I close it.

Filters: no trade within 15 minutes of UK or US data, and no trade if spread is more than 1.5 times normal.

That is the whole card. When I review losing trades on this setup, most of them broke one of these lines, usually the first. Cable passes through lots of round numbers each day, and it is easy to convince yourself every one of them is a level.

I would be interested in how others handle the stop. Do you use a fixed buffer like mine or structure?
Recommended broker for automated trading & scalping IC Markets
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Playbook card: round-number bounce on GBPUSD

Post by Shadow Trader »

LondonScalper, I started with a fixed buffer like yours and slowly moved to a hybrid. The stop goes 1 pip past the rejection wick, but never closer than 3 pips to the round number and never more than 5 pips past it.

A recent cable trade shows why. 1.3400 held in early London, price came back mid morning, and the M1 rejection candle swept to 1.3397 before closing back above the figure.

Entry went on the confirmation break at 1.3404 with the stop at 1.3396, so 8 pips of risk and 1R at 1.3412. That target printed after 11 minutes, inside your 15 minute window.
img_13395_r1.png
img_13395_r1.png (56.46 KiB) Viewed 134 times
The illustration marks the earlier touch, the sweep and those levels on M1. With a fixed 3 pip buffer the stop would have sat right at the wick low, which is the first place a second sweep goes looking.

Where I agree completely is your first filter. Most of my losers on this setup came from figures that had not reacted before, and no stop logic fixes a level that was never real.

Do you count a 50 level that only reacted in Asia as valid, or does it need a London touch? Mine demands a London touch, but I am unsure it earns its keep.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Playbook card: round-number bounce on GBPUSD

Post by Shadow Trader »

LondonScalper, touch count is the filter I would add to the level line on your card. A figure that held once overnight is the best version for me, while a third or fourth return in the same session tends to break, because each test eats into the orders sitting there.

In my cable notes from the last few months, first returns to a figure that had already reacted bounced to 1R about 55 percent of the time. By the third return that dropped to roughly 35 percent, which is below what the setup needs after spread.

The confirmation candle has a cost too. Waiting for the break of the rejection candle put my entries an average of 3 to 4 pips from the figure, which shrinks the room to the next obstacle.

So I check where the next quarter level or the session high sits before entering. If 1R lands beyond it, I pass, since the bounce often stalls right at that point.

I carry Asia touches into the count, which may make my numbers stricter than they need to be. Do you count touches across sessions, or reset the count at the London open?
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Playbook card: round-number bounce on GBPUSD

Post by Shadow Trader »

When trades alternate between hitting the bid and lifting the ask, the recorded price oscillates by the width of the spread even though the underlying value has not changed. This bid-ask bounce creates apparent reversals in tick-level charts that carry no information.

Indicators computed on raw tick prices can respond to this noise. A tick-based oscillator may flip repeatedly, generating signals that reflect the bounce and not any change in supply or demand.

Using mid-prices, or averaging bid and ask, removes much of the effect. Sampling at intervals longer than the typical bounce frequency, such as one second or more, also reduces it. Another approach requires price to move beyond the spread width before treating a change as real. Scalpers working on tick charts benefit from understanding this artifact, since it explains why tick-level strategies often work well in backtests built on trade prices but fail when executed against the quoted bid and ask.
Post Reply