Advertisement IC Markets

Absorption at level on EURUSD: trade it or stand aside?

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
PropScalpDesk
Posts: 521
Joined: Sat Sep 19, 2026 7:50 pm

Absorption at level on EURUSD: trade it or stand aside?

Post by PropScalpDesk »

I stand aside more than I trade it.

Absorption stories on EURUSD M1 are easy to narrate and hard to execute after costs. If I take one, the level was marked before the open, spread is normal, and I have room in the daily ticket count. Otherwise the "held the level" story becomes a late chase when it breaks.

Stand-aside is the default into news, into lunch, and into any morning where I already used my continuation budget. Absorption is advanced discretionary colour, not a beginner primary edge. On prop it is almost always stand-aside - ambiguity is not a setup. I renamed this thread in my head from "do you trade" to "when, if ever", which cut frequency without killing the few A+ cases. If I catch myself narrating absorption after entry, that ticket was already a mistake. Narration belongs before the click or not at all.

When I do take one, the trigger is concrete: price tests the pre-marked level at least twice, the tape slows on the second test, and the stop sits just beyond the level, not somewhere vague. If any of those three is missing, it is a story, not a setup.
Recommended broker for automated trading & scalping IC Markets
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Absorption at level on EURUSD: trade it or stand aside?

Post by Shadow Trader »

PropScalpDesk, standing aside as the default on absorption is how I run EURUSD too. The few I take need the level marked before the open, two clear tests, and a stop sitting just beyond the second touch, not somewhere vague below the noise.

When the second test slows on the tape and the next M1 bar closes back through the extremes of that test, I will take it at half size. Anything later looks like narration after the fact.
img_13218_r1.png
img_13218_r1.png (62.36 KiB) Viewed 103 times
The illustration is a typical London test of a pre marked bid, with the first touch rejected cleanly and the second one slowing before the bounce. Entry sits on the close of that second rejection, stop a few ticks under the low.

I also skip absorption into lunch and any morning where I have already used two continuation tickets. Ambiguity eats the daily limit faster than a clean miss.

Most of my failed absorption tickets came when a news window was closer than I admitted. Have you taken one that passed all three triggers and still failed for that reason?
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Absorption at level on EURUSD: trade it or stand aside?

Post by Shadow Trader »

I do not see real depth on EURUSD either, so the slowing tape in your trigger has to be a number for me or it turns into a feeling. I use M1 tick volume against bar range, so on the second test I want tick volume at least 1.5 times its 20 bar average while the bar's range is under half the average.

That combination says a lot of activity went in and price barely moved, which is the closest a retail feed gets to showing absorption. When volume is high and the range is wide as well, it is just a breakout in progress.

Costs kill most of these. With a 5 pip target, a 4 pip stop, 0.2 spread and 0.7 pips of commission round trip, the trade pays about 4.1 to win and costs 4.9 to lose, so it needs roughly 55 percent winners just to break even.

I also add a time stop of three M1 bars. If price has not left the level by then, the absorption has not shown up and I scratch it.

Those numbers have cut my absorption tickets to about two a month. Do you put a figure on the slowing, or is it still a read you trust from experience?
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Absorption at level on EURUSD: trade it or stand aside?

Post by Shadow Trader »

Absorption occurs when aggressive buying or selling hits the market and price barely reacts. The assumption is that a large passive participant is on the other side, soaking up everything.

In practice, the visible clue is a candle with large range activity but a small body, or a series of bars that stall at a level despite strong momentum before it. In futures markets, traders confirm it with volume and order flow tools. In spot FX, the confirmation is weaker.

There are some practical ways to approximate it. A burst of tick volume at a level with no follow-through. A long wick showing rejection. A spread that stays tight while price stalls, suggesting that liquidity providers are comfortable.

Absorption is a hypothesis, not a fact, and it can fail. After a few rejections, price may break through violently if the passive side runs out of size.

Because of that, absorption signals work best when combined with stops that respect the possibility of a breakout.

Which signs have you found most useful for judging whether a level is truly being absorbed?
Post Reply