Advertisement IC Markets

The one indicator I added back after removing everything

Optimize MetaTrader 4, MetaTrader 5, cTrader, and TradingView for speed. Discuss Level II Market Depth (DOM), custom hotkeys, and volume indicators.
Post Reply
FXS London Scalper
Posts: 1101
Joined: Sun Oct 18, 2026 12:25 pm

The one indicator I added back after removing everything

Post by FXS London Scalper »

Last year I removed all indicators from my charts and traded price only: levels, candles, and session times. It worked fine, and my charts were much cleaner.

But I added one thing back: a simple average of the last 20 bars' range, shown as a number in the corner. Not a line on the chart.

The reason is that I misjudged volatility without it. On quiet days I set targets too far, and on busy days stops too tight. A single number fixed that.

I'm curious which single tool others would keep if they had to choose one.
FXS Official Team | London Session Desk
Recommended broker for automated trading & scalping IC Markets
Shadow Trader
Posts: 5944
Joined: Wed Sep 09, 2026 5:19 pm

Re: The one indicator I added back after removing everything

Post by Shadow Trader »

Everybody knows the first problem. An indicator that redraws past values looks perfect in hindsight and gives signals that never existed in real time. That is old news.

The second problem gets far less attention. Many repainting indicators are repainting because they recalculate a long stretch of history on every tick. That is how they get to change old values. The same design that makes the signal unreliable also makes the indicator expensive to run. Load a handful of them on several charts and the terminal starts lagging in fast markets, which delays the very entries those indicators were supposed to help with.

Blunt opinion: an indicator that both repaints and burns processor time has no place on a scalping chart. The signal cannot be trusted, and the cost shows up as slower execution on the whole platform.

A quick way to spot the problem is to watch the chart at the live edge for a few minutes and note whether past arrows or lines shift, then check how the platform responds when the indicator is added to a busy chart.

Which indicators have you caught repainting, and did removing them make the terminal noticeably smoother?
Amanhasnoname
Posts: 2399
Joined: Fri Oct 30, 2026 9:45 am

Re: The one indicator I added back after removing everything

Post by Amanhasnoname »

A single average-range number is a good compromise, and the reason it works is that it answers a different question from the chart. Price action tells you where to trade, while the range figure tells you how much room a trade needs. Setting stops and targets as a fraction of that number keeps them proportional on both quiet and busy days.

The common pitfall is treating it as a signal rather than a ruler. A rising average range means wider stops are needed, but it does not say which way price will go. It also lags, so after a news spike the number stays high for a while and can make targets look further away than the current session really supports.

Before relying on it, check which period suits your holding time. A shorter window reacts faster but jumps around, while a longer one is steadier but slow to adapt. Compare a few lengths against your own typical trade duration, and see whether stops placed from the number get hit less often than fixed pip stops. Also check it separately for each session, since London and late New York ranges differ a lot.
Post Reply