Advertisement IC Markets

Does a 20 ms latency cut change EURUSD M1 results? A test design

Compare ECN/Raw spread brokers, analyze execution speeds, report slippage, and evaluate commission structures for high-frequency traders.
Post Reply
FXS London Scalper
Posts: 975
Joined: Sun Oct 18, 2026 12:25 pm

Does a 20 ms latency cut change EURUSD M1 results? A test design

Post by FXS London Scalper »

Switching from a home line to a VPS hosted near the broker's server is the classic latency upgrade. Whether it changes results for an M1 EURUSD scalper is testable, and the answer is often smaller than expected.

A clean comparison:
  • Run the same rules from both locations for the same weeks, ideally with a copier so entries are simultaneous.
  • Log ping to the trade server, request-to-fill time from the Journal, and slippage per fill against the requested price.
  • Split results by hour, because the open and data minutes are where latency could matter.
What to look at: average slippage per trade in pips, and the share of fills with any slippage at all. If 25 ms versus 2 ms produces no measurable difference outside the first minutes of London, the upgrade is mostly about reliability, not speed.

A worked example of scale: if latency costs 0.05 pips per trade on average, that's $0.50 per lot. On 300 lots a month, $150, which can be more or less than a VPS costs. The number decides it, not the feeling of speed.

Has anyone run both setups side by side and kept the logs?
FXS Official Team | London Session Desk
Recommended broker for automated trading & scalping IC Markets
Amanhasnoname
Posts: 2060
Joined: Fri Oct 30, 2026 9:45 am

Re: Does a 20 ms latency cut change EURUSD M1 results? A test design

Post by Amanhasnoname »

Running both locations through a trade copier is the cleanest part of that design, because otherwise market conditions differ between the two samples and swamp any latency effect. One extra thing to log is the copier's own delay, since a slow copier can add more milliseconds than the VPS saves and quietly bias the comparison in favour of the master side.

It is also worth separating requote and rejection counts from slippage. On some execution models a faster connection does not change the fill price much but does reduce the number of orders that bounce during fast moves, and that shows up in missed trades rather than pips. For an M1 system with tight stops, a handful of rejected entries in the open can matter more than the average slippage figure.

The sample size needs some care too. Slippage per trade is noisy, so a few weeks may not be enough to separate 0.05 pips from zero. Grouping the results by the volatile minutes versus the quiet hours, as you suggest, gives a far clearer answer than one overall average.
Post Reply