Advertisement IC Markets

Once price blasts through an FVG on USDCAD, I stop treating that gap as a POI

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Once price blasts through an FVG on USDCAD, I stop treating that gap as a POI

Post by Fairman »

An FVG that price only nicks is still a point of interest. An FVG that price closes through and leaves behind is not, at least not as the original idea.

The schematic starts with a bullish gap on USDCAD between 1.36800 and 1.36920. If price had dipped into that gap and held, I would have considered a long. Instead it drives through, and the next candle closes under it at 1.36680. That gap is spent. Later there is a bounce back into 1.36840, which looks like a retest, and I used to buy that. I don't anymore. The close through already told me the imbalance had been used the other way.

The walkthrough I want after the blast is the short, not the retest long. Entry 1.36720, stop 1.36900, 18 pips. Target 1.36360, 36 pips, 2R. At 1.36800, a USDCAD pip is about $7.31 per lot, so 0.30 lot risks about $39.50.

A wick through the gap is not the same thing. I need a close beyond it before I take the POI off the chart.
07-usdcad-blasted-fvg.png
07-usdcad-blasted-fvg.png (82.39 KiB) Viewed 33 times
It’s Fairman :geek:
Recommended broker for automated trading & scalping IC Markets
Amanhasnoname
Posts: 2060
Joined: Fri Oct 30, 2026 9:45 am

Re: Once price blasts through an FVG on USDCAD, I stop treating that gap as a POI

Post by Amanhasnoname »

Treating a gap as spent once a candle closes through it is a good rule, mostly because it replaces a feeling with something you can check. The thing I would look at is what counts as a close through. A close beyond the far edge of the gap on your trading timeframe is clean, but a close only inside the gap or a bar that wicks through and closes back is different information, so write down exactly which one you accept and apply it every time.

For the retest after the blast, the useful test is whether it is rejected or accepted. A weak, small-bodied bounce that stalls under the old gap and then rolls over is a better short than a sharp rebound that spends several candles back inside the zone. Tag each retest in a journal as rejected or accepted and see which group actually pays.

Keep in mind that USDCAD often reacts to oil and US data, so a blast through a gap near a release may say little about structure. Filter those events out and compare results before trusting the rule. Also check that the stop sits beyond the retest high with room for the spread, and size from that distance.
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Once price blasts through an FVG on USDCAD, I stop treating that gap as a POI

Post by Fairman »

Blasted through, for me, means a close beyond the far side of the gap, not a wick that pokes through and comes back. A wick through 1.36800 that closes back inside 1.36800-1.36920 can still be a hold, and I will treat that as a test, not a failure. The close is the thing I wait for, same as I do with a break of structure. If I start calling every wick a blast, I will abandon good gaps too early and then watch them hold without me. The schematic's close at 1.36680 is the version that counts.
It’s Fairman :geek:
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Once price blasts through an FVG on USDCAD, I stop treating that gap as a POI

Post by Fairman »

Once the gap has been accepted through, I may use the other side of it later as a flip zone, but that is a new idea, not the original long. The old bullish FVG does not become a guaranteed short either. I want a shift, a close, and then I can mark the underside of 1.36800 as possible resistance. I mention this so it doesn't sound like I just reverse the trade the moment the gap fails. The failed gap removes the long. It does not, by itself, hand me a short.
It’s Fairman :geek:
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Once price blasts through an FVG on USDCAD, I stop treating that gap as a POI

Post by Fairman »

A partial fill is also different from a blast. If price comes into the gap, fills half of it, and holds, the remainder is still a POI. Consequent encroachment, the midpoint of the gap itself, is often enough for me. The 1.36800-1.36920 gap would still be alive after a dip to 1.36860. What kills it is the close through the bottom, not the fact that some of the imbalance got traded. I used to treat any touch as a full fill and then have no level left. That was sloppy marking, not a rule.
It’s Fairman :geek:
Post Reply