Some sessions just don't move. The range is small, candles overlap, and every breakout gets pulled back. Most scalpers have a sense of when this is happening, but a sense is easy to argue with when you're bored and want to trade.
There are a few simple numbers that can turn the feeling into a check.
The range so far compared with the average for that time of day. If the first two hours of London have produced 40 percent of the usual range for those hours, conditions are quieter than normal regardless of how they look.
ATR on a short timeframe compared with the spread. If the five-minute ATR is only three or four times the spread, a lot of each move is being eaten by cost. When it's ten times or more, there's more room for a short-term trade to work.
The number of candles closing outside the previous candle's range. In choppy conditions, most candles stay inside or barely poke out. In a moving market, more of them close beyond the prior candle.
None of these needs special software, and they can be written down at a fixed time, for example after the first hour, before deciding whether to trade normally, trade smaller or step away.
The useful part is checking them against results later. If trades taken when the range-to-average figure was below a certain level have a noticeably worse result, that's a reason to treat it as a filter rather than a hunch.
What do others use to decide a market is too flat to bother with? Is it a number, or mainly experience?
Measuring whether a market is moving enough to be worth scalping
-
Shadow Trader
- Posts: 5594
- Joined: Wed Sep 09, 2026 5:19 pm