ATR gets used a lot for stop placement, usually something like a stop at 1 or 1.5 times the ATR so the stop adapts to how much the market is moving. It's used much less often for targets, even though the same logic applies. If the market is moving twice as much as usual, a fixed 10-pip target is relatively small. If it's barely moving, the same 10 pips might be unrealistic.
A few ways to bring ATR into targets:
Fixed multiple. Target at, say, 1.5 times the ATR of the timeframe you're trading. Simple, and it keeps the reward-to-risk ratio constant if the stop is also ATR-based.
Remaining daily range. Compare how far price has already moved today with the average daily range. If 80% of a typical day's range is already done, a target that needs another full ATR is less likely to be reached than the same target early in the session.
Session-adjusted ATR. ATR calculated over the whole day blends quiet Asian hours with busy London hours. For a scalper working only one session, an ATR calculated on just those hours is usually more representative.
The caveat is that ATR is backward-looking. It tells you how much the market has been moving, not how much it will move, so a sudden change after news or a quiet holiday afternoon can make the number misleading for a while.
It would be interesting to hear whether anyone uses volatility-based targets for scalping, or whether fixed pip targets work better on very short timeframes because spread and commission stay fixed regardless of volatility.
Using ATR for targets as well as stops
-
Shadow Trader
- Posts: 5594
- Joined: Wed Sep 09, 2026 5:19 pm