This is the arithmetic I keep getting asked about, so I'm writing it out properly.
Say gold sweeps a set of equal highs and leaves a $12 wick, like the 3,954 to 3,966 poke on the schematic. I don't put the stop at 3,954. I put it past the wick, here 3,969, three dollars beyond the high. If I enter at 3,938 after the MSS, the stop is $31 wide.
On my broker 1.00 lot is 100 oz, so $1 = $100 a lot. A 0.04 lot (4 oz) with a $31 stop is $124 of risk. That's 1.24% of a $10,000 account, which is too much for a single scalp. 0.01 lot is 1 oz, $31 of risk, 0.31% of the account. That's the size I actually use when the wick forces the stop out this far.
People try to 'keep the stop tight' by sitting it inside the wick. Then the same sweep that makes the setup valid takes them out, and they re-enter twice. I'd rather take one 0.01 lot with a stop that has room, than three 0.04 lots that all die on the noise.
The target on the schematic is 3,884, which is $54 from 3,938, about 1.7R on a $31 stop. Not a miracle R-multiple. It's an honest one.
Sizing a gold short on a $10,000 account when the stop has to sit beyond a $12 wick
-
Amanhasnoname
- Posts: 2060
- Joined: Fri Oct 30, 2026 9:45 am
Re: Sizing a gold short on a $10,000 account when the stop has to sit beyond a $12 wick
Putting the stop past the wick rather than on it is the right call, and the sizing follows directly from that. The sweep is what makes the setup valid, so a stop that sits inside it is effectively betting the liquidity grab is already finished. Working from risk in dollars first and letting the lot size fall out of the stop distance keeps the logic honest, even when it means trading a size that feels almost too small.
One thing worth checking is how the contract size is defined on each platform. Some brokers quote gold at 100 oz per lot, others at 10 or even 1, and the same "0.04" can mean very different exposure. Spread on gold also widens a lot around the New York open and data releases, so a $31 stop can effectively become $33 or $34 once the spread is added on the exit side.
It's also worth testing whether a partial at 1R plus a runner to 3,884 improves the equity curve compared with holding the whole position to the full target, since gold often retraces sharply before extending.
One thing worth checking is how the contract size is defined on each platform. Some brokers quote gold at 100 oz per lot, others at 10 or even 1, and the same "0.04" can mean very different exposure. Spread on gold also widens a lot around the New York open and data releases, so a $31 stop can effectively become $33 or $34 once the spread is added on the exit side.
It's also worth testing whether a partial at 1R plus a runner to 3,884 improves the equity curve compared with holding the whole position to the full target, since gold often retraces sharply before extending.
Re: Sizing a gold short on a $10,000 account when the stop has to sit beyond a $12 wick
If the stop had to be $18 beyond the wick instead of $3, the same logic just shrinks the lot again, or I pass. $12 wick plus $18 cushion is a $30 add-on before you even count the entry distance. I have a hard cap of about $40 of risk, 0.4% of the $10,000. If the stop I need is $45 wide, then even 0.01 lot is $45, which is already over the cap, and I don't take the trade. There will be another FVG tomorrow. There won't be another $10,000 if I keep making exceptions.
It’s Fairman 
Re: Sizing a gold short on a $10,000 account when the stop has to sit beyond a $12 wick
Comparison with a 0.10 lot, because that's the size a lot of $10,000 accounts start clicking when gold is moving. 0.10 lot is 10 oz. A $31 stop is $310, which is 3.1% in one trade. Two of those in a row and you're down 6% before lunch. Gold feels like it 'needs' size because the dollar moves look large. The contract is what makes them large. Size from the stop and the dollar risk, not from how exciting the candle looks. The 0.10 lot habit usually comes from watching someone else's 100k account screenshots. On $10,000 it just doesn't belong, especially on gold.
It’s Fairman 
Re: Sizing a gold short on a $10,000 account when the stop has to sit beyond a $12 wick
One check I do before I send the order: write the three numbers on the pad. Stop width in dollars, lot size, dollar risk. 31 x 1 oz = 31. If I can't do that in my head in a few seconds I am not ready to click. On EURUSD I can size faster because a pip is $10 and I do it all day. Gold I slow down for, every time, even when the setup is obvious. If the three numbers don't fit the $40 cap, I don't 'just this once' them. I pass, and I don't owe the chart an entry.
It’s Fairman 