Limit entries for reversion, market entries for momentum
A common rule of thumb pairs order type with trade type. Reversion setups, where price is expected to return, suit limit orders placed at the extreme. Momentum setups, where the move is expected to continue, suit market or stop orders.
The reasoning is simple. In reversion, waiting for price to come to the level gives a better price and fits the thesis. In momentum, waiting for a pullback risks missing the move entirely.
Mixing them causes trouble. A limit entry on a momentum trade fills only when the trade is failing. A market entry on a reversion trade pays extra spread and often gets in too early.
The lines are not rigid. Some momentum traders use limits on shallow pullbacks, and some reversion traders use market orders at confirmed rejection. But the starting point is a good one.
A review of the trade log by order type and setup type can show whether the pairing matches reality, or whether some trades are using the wrong tool.
A simple audit is listing the last fifty trades with their setup type and order type, then calculating the average result for each combination. Mismatches show up quickly.
Do the order types in use match the logic of the setups?
Limit entries for reversion, market entries for momentum
-
Amanhasnoname
- Posts: 2060
- Joined: Fri Oct 30, 2026 9:45 am
Re: Limit entries for reversion, market entries for momentum
What changed my mind on this was a breakout system I ran on GBPUSD during the London open. I used to wait for a pullback of three or four pips after the break and rest a buy limit there, because paying the ask on a move that had already run felt expensive. Over a couple of months the limits filled on about forty percent of signals, and the fills were heavily tilted toward the breaks that later failed. The clean runners simply left without me.
When I switched that same setup to a stop order a pip beyond the range, the fill price was worse by roughly half a pip on average, but I was in every trade that actually went somewhere. The net result went from slightly negative to modestly positive, and that was entirely down to which trades I ended up holding.
On my fade trades at the edges of the Asian range I still use resting limits, because there the extreme is the whole idea. Matching the order to the reason for the trade has been one of the cheapest fixes I have made.
When I switched that same setup to a stop order a pip beyond the range, the fill price was worse by roughly half a pip on average, but I was in every trade that actually went somewhere. The net result went from slightly negative to modestly positive, and that was entirely down to which trades I ended up holding.
On my fade trades at the edges of the Asian range I still use resting limits, because there the extreme is the whole idea. Matching the order to the reason for the trade has been one of the cheapest fixes I have made.
-
FXS HongKong Scalper
- Posts: 543
- Joined: Sat Oct 24, 2026 10:15 pm
Re: Limit entries for reversion, market entries for momentum
The pairing makes sense. One exception worth noting: in reversion setups during news, limits get filled exactly when the move is strongest, which is when reversion fails most often. So the rule probably needs a news filter on the limit side.
FXS Official Team | Hong Kong Session Desk