Advertisement IC Markets

Ethernet, Wi-Fi and a phone hotspot: it is jitter that hurts, not speed

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Ethernet, Wi-Fi and a phone hotspot: it is jitter that hurts, not speed

Post by Shadow Trader »

A speed test result is nearly irrelevant for trading. An order is a few hundred bytes. Whether the line can pull down 300 Mbps or 30 Mbps makes no difference to something that small.

What matters is how consistent the delay is. Jitter is the variation from one packet to the next. A connection that takes 15 ms every single time is far better for execution than one that averages 10 ms but sometimes takes 80 and sometimes 8.

Wi-Fi tends to be the jittery one. It shares airtime with neighbours, microwaves, and every other device in the house, and it retransmits lost packets, which looks like random spikes. A wired Ethernet cable removes most of that variation, which is why it is the usual recommendation.

A mobile hotspot adds another layer. Signal strength changes, the carrier may route traffic through different gateways, and some networks put many users behind shared address translation. Average speed may look great while the delay swings unpredictably. It works fine as a backup, but a poor primary link for tight entries.

A simple way to see the difference is to run a continuous ping to the broker or a stable server for a few minutes on each connection and look at the spread of times, not just the average.

Has anyone measured jitter on their own connections, and how much did Wi-Fi really differ from a cable in practice?
Recommended broker for automated trading & scalping IC Markets
FXS London Scalper
Posts: 978
Joined: Sun Oct 18, 2026 12:25 pm

Re: Ethernet, Wi-Fi and a phone hotspot: it is jitter that hurts, not speed

Post by FXS London Scalper »

Shadow Trader wrote: An order is a few hundred bytes.
The point that a few hundred bytes don't care about bandwidth is worth repeating. A ping logged every second for an hour, then looking at the 99th percentile rather than the average, shows jitter clearly. Running it at 08:00 London, when the home network and the ISP are busy, is the realistic test.
FXS Official Team | London Session Desk
Amanhasnoname
Posts: 2060
Joined: Fri Oct 30, 2026 9:45 am

Re: Ethernet, Wi-Fi and a phone hotspot: it is jitter that hurts, not speed

Post by Amanhasnoname »

I did exactly this test about two years ago when I moved my trading desk into a back room far from the router. On Wi-Fi the average ping to my broker's server looked fine, roughly in the high twenties, but every few minutes there would be a spike well over a hundred, and in the evening when the rest of the house was streaming it got noticeably worse. On a long cable run to the same router the average barely changed, but the spikes almost disappeared.

The phone hotspot was the real surprise. The average was not awful, yet the worst readings over an hour were several times higher than either of the other two, and twice the connection dropped entirely for a few seconds. I would never want an open scalp relying on that.

So I ran a flat cable along the skirting board and kept the hotspot only for emergencies, mainly to close positions if the home line goes down. It is also worth checking the platform itself, since mine shows its own ping in the corner and that number matched my tests closely.
Post Reply