Advertisement IC Markets

Round-turn cost: why commission quoted per side is misleading

Compare ECN/Raw spread brokers, analyze execution speeds, report slippage, and evaluate commission structures for high-frequency traders.
Post Reply
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Round-turn cost: why commission quoted per side is misleading

Post by Fairman »

Round-turn cost: why commission quoted per side is misleading

A quoted commission of 3.5 dollars per side per lot sounds small. Then the round turn gets calculated at 7 dollars, and the spread comes on top. For a scalper with a 4 pip target, the cost structure matters more than almost any entry refinement.

Convert everything to pips for each trade. On EUR/USD, one pip per lot is 10 dollars, so 7 dollars in commission equals 0.7 pips. Add a 0.3 average spread and the total friction is a full pip. That is a quarter of a 4 pip target before the market does anything.

Now compare systems. A strategy with an average win of 4 pips and a 50 percent win rate looks fine on paper. After a pip of friction, the expectancy drops sharply. Cut the win to 3 pips and the same win rate can go negative.

The takeaway is to always view targets net of costs, and to set a minimum target at some multiple of friction, such as five times, before a setup is even worth considering.

What cost ratio does a setup need to clear before it gets traded?
It’s Fairman :geek:
Recommended broker for automated trading & scalping IC Markets
Amanhasnoname
Posts: 2060
Joined: Fri Oct 30, 2026 9:45 am

Re: Round-turn cost: why commission quoted per side is misleading

Post by Amanhasnoname »

A per-side commission always sounded smaller than it was. The broker quoted four dollars each way, which is eight dollars round turn, and on EURCHF that converted to about zero point seventy-three pips before the spread. My average spread there added another forty-eight hundredths, so total friction sat near one point two pips. Against an average win of five and a half pips that is already a large bite, more than a fifth of the target before the market moves.

I now require a planned target of at least six times round-turn friction before a setup gets anywhere near a live account. Anything thinner gets parked. Two patterns I liked, which only cleared about three and a half times costs, ran slightly negative across nine weeks of journaled trades once I stopped ignoring commission.

Viewing everything net of costs also changed which pairs I bother to scalp. If the friction cannot be measured in the same units as the target, I do not trust the expectancy. The per-side quote is a marketing number; the round turn is the one that hits the account.
Post Reply