Protecting the higher low: where stops belong in a trend continuation
In an uptrend, the last higher low is the level that, if broken with a close, would turn the structure. So it seems natural to put stops just below it. The problem is that this level is also the most visible, so it is often swept before price continues. My approach is to separate invalidation from placement. Invalidation is the close below the higher low on the trading timeframe. Placement is where I physically put the stop to survive normal noise, usually below the sweep zone with a buffer. If the position size would be too large with that wider stop, I reduce size rather than tighten the stop. I also avoid adding to winners right at the higher low, because that is where reversals begin. I add only after a new break confirms the trend is still intact. This keeps risk consistent and avoids the cycle of being stopped out by a wick right before the move that you predicted.
Protecting the higher low: where stops belong in a trend continuation
Re: Protecting the higher low: where stops belong in a trend continuation
Reducing size instead of tightening the stop is the key line here, and it's the one people skip because a smaller position feels like a smaller opportunity. The R is the same either way though. One more detail: spread can widen right where these sweeps happen, especially around session opens, so the buffer below the higher low should account for the spread you'd see at that time of day, not the quiet average. On a pair like GBPJPY that difference can be large enough to decide whether you're stopped out or not, so I'd check the spread history first.
It’s Fairman 
Re: Protecting the higher low: where stops belong in a trend continuation
Something to think about with trailing in a continuation: if you move the stop under each new higher low as it forms, you're putting it right back into the obvious spot the post warns about. I'd trail to the zone below the higher low, or only trail once the next break has closed, so you're not tightening into a level that's likely to get swept. It is slower and gives back a bit more on reversals, but it stops the pattern of getting wicked out and then watching the trend carry on without you. How do others here handle trailing in this style?
It’s Fairman 
Re: Protecting the higher low: where stops belong in a trend continuation
Spread is something I'd factor into where the stop goes under a higher low. If the low is at 1.0850 and you put the stop at 1.0848 on a long, the stop triggers on the bid, and if spreads widen at a roll or a data release, a two pip buffer can disappear without price really breaking the low. A slightly bigger buffer, or simply avoiding holding through the rollover with a tight stop, saves a lot of those annoying exits. The chart shows bid prices, so it never quite looks like the low was taken.
It’s Fairman 
-
FXS Prop Desk
- Posts: 1693
- Joined: Wed Oct 07, 2026 9:52 am
Re: Protecting the higher low: where stops belong in a trend continuation
If the higher low is the obvious place, a stop a bit further away, sized down to keep the same risk, survives the sweep that so often comes first.
The other option is to wait for that sweep and enter after it, with the stop beyond the sweep's low. It means missing trades that continue without a sweep, but those that do sweep give a better price and a more logical stop.
The other option is to wait for that sweep and enter after it, with the stop beyond the sweep's low. It means missing trades that continue without a sweep, but those that do sweep give a better price and a more logical stop.
FXS Official Team | The Idea Lab & Strategy
Re: Protecting the higher low: where stops belong in a trend continuation
There's also the question of which higher low counts. In a strong trend on M5 you might get a tiny higher low every few candles, and protecting each one means very tight stops. Using the higher low that formed after a proper pullback, one that actually tested something like a prior level or the moving average, gives a more meaningful stop. It's further away, so size has to come down, but at least the stop sits where buyers actually showed up rather than at a two candle wiggle. A wider stop at a real low usually survives the normal noise that kills the tight ones.
It’s Fairman 