Advertisement IC Markets

USDCHF tape read: absorption then reject at Asia high

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
LondonScalper
Posts: 965
Joined: Sat Sep 05, 2026 7:54 am

USDCHF tape read: absorption then reject at Asia high

Post by LondonScalper »

USDCHF absorption then rejection at the Asia high is a pattern I take rarely, maybe twice a month. It only qualifies under fairly narrow conditions.

The Asia high must be marked before London opens. Price approaches it in the first hour, and instead of breaking through, it trades into it several times over five to ten minutes with small candles while the tape slows. Then a clear M1 rejection candle closes back below the level. That is the entry signal, with the stop above the high of the absorption area.

Spread must be normal. USDCHF can widen around 07:00 to 08:00 on my account, and if it is wider than usual, a stop above the high becomes too expensive relative to the target.

Time stop is short, fifteen minutes. If the rejection does not follow through quickly, the absorption was probably just a pause before a break.

The reason I take it so rarely is that most days the "absorption" turns out to be accumulation, and the high breaks anyway. Without the clean rejection candle, it is a narrative wearing a setup costume.

Average result over the last year is small but positive. Not exciting, but cheap to monitor.
Recommended broker for automated trading & scalping IC Markets
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: USDCHF tape read: absorption then reject at Asia high

Post by Shadow Trader »

LondonScalper, the clean M1 rejection requirement is what keeps this from turning into a story. I logged 18 USDCHF approaches to the Asia high last quarter where price tapped the level three or more times, and only 5 printed the clear close back below that you describe.

Of those 5, three worked inside the fifteen minute time stop, one scratched, and one broke higher after a fake rejection wick. That is a tiny sample, but it matches your point that most absorption is just a pause.
img_13424_r1.png
img_13424_r1.png (77.45 KiB) Viewed 125 times
The illustration sketches a qualifying reject versus a pause that later broke. Spread in the first London hour decided two of the five for me: when it was already wide, the stop above the absorption high simply cost too much relative to a 6 to 8 pip target.

I still mark the Asia high every morning, but I only arm the alert if the approach is slow and the tape is quiet. Fast thrust into the high gets ignored.

Do you ever take the same shape on EURCHF, or is the USDCHF session behaviour different enough that you keep it pair specific? Mine stays pair specific for now.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: USDCHF tape read: absorption then reject at Asia high

Post by Shadow Trader »

Looking back at my five qualifying rejections, the one that failed had something in common with the scratch. In both cases EURUSD was breaking below its own Asia low at the same time, so the dollar was bid across the board and USDCHF had a reason to push through.

The three that worked all came on mornings when EURUSD was flat or rising in the first London hour. That is a tiny sample, but it is the only filter I have found that does not just restate the pattern.

So I now glance at EURUSD before arming the USDCHF alert. If the dollar is clearly strong on the other major, I treat a rejection at the Asia high as a pause by default.

My target is the midpoint of the Asia range rather than a fixed pip count. On the three winners that midpoint sat between 7 and 11 pips away, close to what the time stop allowed anyway.

Do you check any other dollar pair before taking it, or do you keep the read purely on the USDCHF tape? I would rather drop the trade than add a third screen to watch.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: USDCHF tape read: absorption then reject at Asia high

Post by Shadow Trader »

EURUSD and USDCHF move in opposite directions most of the time, with a correlation around minus 0.9. Having one of each open looks like holding two different trades. Often it's the same trade twice.

Work through the direction. A long EURUSD position profits when the euro rises against the dollar, which means the dollar is weakening. A short USDCHF position profits when the dollar falls against the franc, which is again a weaker dollar. Both positions are bets on the same thing, so a trader holding them has doubled the dollar exposure, plus two spreads and two commissions.

The mistake is common among those who like to see "different" instruments in the open positions list. Each chart looks different, and the entry signals come at different times. The exposure doesn't differ.

The reverse mistake exists too. A long EURUSD alongside a long USDCHF looks like twice the position, but the two largely cancel in a dollar move, leaving the trader with a small bet on the euro against the franc and a lot of cost.

A quick check is to convert open positions into net exposure by currency: long EUR, short USD, short CHF, and add them up. Some platforms have an exposure widget or a plug-in for it, and a spreadsheet works fine.

Sometimes the result shows that three open positions are really one trade in disguise. Which pairs have seemed independent but turned out to be the same bet?
Post Reply