Navigate the rules, daily drawdown limits, and consistency guidelines of prop trading firms. Discuss how to pass funded account challenges using scalping strategies.
The rule that caught a friend of mine wasn't one of the obvious ones. His copier failed to close the follower after the master hit its stop, he went short on the master ten minutes later, and for twenty minutes he was long on one account and short on the other at the same firm.
Nobody intended a hedge, but the logs look exactly like one. Since then my copier checks that every follower is flat before the master can open the opposite direction, and it alerts if positions differ for more than 5 seconds.
A straight multiplier assumes both accounts are in the same state, and they rarely are. If the 100k is funded with 8% drawdown left and the 50k is in phase 2 with 3% left, the same proportional trade eats very different shares of each one's headroom.
So I size the follower from its own remaining daily loss, not from the master's lots. The copy often ends up smaller than the multiplier says, which I'm fine with.
For latency, I run a local copier on the same VPS as both terminals and log fill time and price on each side. Mine sits around 50 to 90 ms, and the gap only shows around releases. Have you compared a cloud copier on the same trades?
FXS Prop Desk, challenge and funded copy rules diverge more than the marketing page admits. One firm allowed a 1:1 copy across two challenge accounts, then banned the same link the day either account funded, which I only caught in a support thread after the fact.
I now keep challenge accounts on a separate copier profile with its own kill switch. Mixing a funded book that can hold overnight with a challenge that must flat by 21:50 is how desync starts.
Partial fills are the other desync source. If the master gets 0.6 of 1.0 lots and the follower fills the full rounded lot, risk drifts, and a later partial close can leave the follower naked by a few tenths.
My copier now compares filled volume within 2 seconds and pauses both sides if the gap exceeds 0.05 lots. Have you seen partial fill drift force a manual flatten, or does your lot rounding keep both sides matched?
Most traders trust the broker statement and their own journal without comparing the two. Mismatches are more common than expected, and they can reveal real issues.
Differences may include trades missing from the journal, commissions that differ from the advertised rate, swap charges that do not match the published values, and fills at prices that deviate from what the platform displayed.
A monthly reconciliation is not complicated. Export the account history, and match each trade to the journal entry by time and size. Check commission, swap, and the closing price. Flag any line that does not agree.
Most discrepancies will have innocent explanations, such as rounding, time zone differences, or a platform setting. A few might not, and finding them early gives time to ask questions while the records are fresh.
The habit also builds a cleaner record for tax purposes, and it makes it easier to analyse costs accurately.
How often do you compare your own records with the broker statement, and have you ever found something unexpected?