The Pin Bar: A Candle That Tells You Where Price Was Rejected
A pin bar has a small body and one long wick, at least about two-thirds of the candle's total length. A long upper wick means price rose and was pushed back down. A long lower wick means price dropped and was pushed back up.
The story is rejection. Within that period, one side tried to move price and failed, and the close returned near the open.
Location decides whether it matters. A pin bar in the middle of a range means little. One that forms at a support zone, a prior swing, or a higher-timeframe level carries information, because it shows that the level held when tested.
Entry methods vary. Some traders enter on the close of the pin bar, others place a stop order beyond its body to wait for confirmation. The stop usually goes beyond the tip of the wick, which can be wide, so lot size must adjust.
Not all long wicks are rejection. During news, wicks can be the product of thin liquidity and spread widening rather than genuine buying or selling.
A pin bar is a hint, not a prediction. It increases the odds somewhat when the surrounding conditions agree.
Practical step: find ten pin bars on your chart, and sort them by whether they formed at a meaningful level. Compare the outcomes.
The Pin Bar: A Candle That Tells You Where Price Was Rejected
Re: The Pin Bar: A Candle That Tells You Where Price Was Rejected
A caveat on pin bars: where it forms matters more than how it looks. A textbook pin bar floating between levels with nothing around it is just a candle. The same pin at a higher timeframe level after a sweep is a lot more interesting. Timeframe also matters. A pin on the daily chart represents a full day of rejection. A pin on the 5 minute chart might be one order being filled. I'd also watch what the next candle does. If it breaks the pin's high in the direction of the rejection, the signal is confirmed. If it breaks the tip of the wick instead, the rejection failed, and that can be a useful signal in the other direction.
It’s Fairman 
Re: The Pin Bar: A Candle That Tells You Where Price Was Rejected
A thing about the stop: I put it a few pips beyond the end of the wick, not right at it. The wick tip is where rejected orders sat, and price sometimes comes back to tap it once more before going. On EURUSD that's 2 or 3 pips plus the spread. Location matters more than shape too. A pin bar at a daily level after a sweep of a previous high is meaningful. The identical candle floating halfway up a choppy range is just a candle. Also check the size. A pin bar much smaller than recent candles carries less information than one that stands out.
It’s Fairman 
-
Shadow Trader
- Posts: 5594
- Joined: Wed Sep 09, 2026 5:19 pm
Re: The Pin Bar: A Candle That Tells You Where Price Was Rejected
The stop beyond the wick is where sizing bites, because a clean pin often needs the widest stop of any nearby candle. Entering on the close and on a pullback into the wick are very different trades from the same candle.
In the made up chart, the 15 minute pin at support has a 16 pip lower wick on a 24 pip candle, low 1.0842. With the stop 3 pips under the tip, entry on the close at 1.0862 risks 23 pips, while a limit at the midpoint of 1.0854 risks 15.
Aiming for the prior swing high at 1.0900, that is about 1.7R against roughly 3.1R. Risking 50 dollars, size goes from about 0.22 lots to 0.33.
The catch is that the strongest rejections rarely come back to the midpoint. The limit misses the trades that leave straight away and fills on the ones that drift back toward the tip.
Fairman's next candle idea is the third option: buy the break of the pin high at 1.0866 with the same stop, risking 27 pips for proof the rejection held. Which of the three do people here actually use at a level?
In the made up chart, the 15 minute pin at support has a 16 pip lower wick on a 24 pip candle, low 1.0842. With the stop 3 pips under the tip, entry on the close at 1.0862 risks 23 pips, while a limit at the midpoint of 1.0854 risks 15.
Aiming for the prior swing high at 1.0900, that is about 1.7R against roughly 3.1R. Risking 50 dollars, size goes from about 0.22 lots to 0.33.
The catch is that the strongest rejections rarely come back to the midpoint. The limit misses the trades that leave straight away and fills on the ones that drift back toward the tip.
Fairman's next candle idea is the third option: buy the break of the pin high at 1.0866 with the same stop, risking 27 pips for proof the rejection held. Which of the three do people here actually use at a level?
-
FXS Prop Desk
- Posts: 1692
- Joined: Wed Oct 07, 2026 9:52 am
Re: The Pin Bar: A Candle That Tells You Where Price Was Rejected
The observation about location is key. One additional filter that helps is the size of the pin bar relative to recent candles. A small pin bar on a quiet chart often means little, while one with a range larger than the average of the last 10 candles, at a level the trader had marked in advance, shows a more meaningful rejection.
FXS Official Team | The Idea Lab & Strategy
-
Shadow Trader
- Posts: 5594
- Joined: Wed Sep 09, 2026 5:19 pm
Re: The Pin Bar: A Candle That Tells You Where Price Was Rejected
FXS Prop Desk's size filter has a cost that shows up in the stop. A pin with twice the range of the 10 candle average is the more convincing rejection, but the stop beyond its tip is also about twice as far, so the position halves and the target has to be twice as far away to keep the same R.
One way around it is to judge the pin on the higher timeframe and take the entry on a lower one. Say a 1 hour pin at a daily level has a 30 pip wick, then a 5 minute break of structure inside the upper half of that wick can carry a stop of 8 to 10 pips.
It is worth checking when the wick was printed. A tail made around 10pm Lagos rollover can be nothing more than the spread blowing out on a platform that plots the bid, with no real selling or buying behind it.
The same goes for pins built around a data release. If the whole wick came from one 1 minute candle at 1:30pm, it says more about thin liquidity in that minute than about the level holding.
Has anyone compared pins formed in the last few minutes of the candle with ones that build steadily? Same shape, very different story.
One way around it is to judge the pin on the higher timeframe and take the entry on a lower one. Say a 1 hour pin at a daily level has a 30 pip wick, then a 5 minute break of structure inside the upper half of that wick can carry a stop of 8 to 10 pips.
It is worth checking when the wick was printed. A tail made around 10pm Lagos rollover can be nothing more than the spread blowing out on a platform that plots the bid, with no real selling or buying behind it.
The same goes for pins built around a data release. If the whole wick came from one 1 minute candle at 1:30pm, it says more about thin liquidity in that minute than about the level holding.
Has anyone compared pins formed in the last few minutes of the candle with ones that build steadily? Same shape, very different story.
-
Shadow Trader
- Posts: 5594
- Joined: Wed Sep 09, 2026 5:19 pm
Re: The Pin Bar: A Candle That Tells You Where Price Was Rejected
A five-minute candle is normally the combination of five one-minute candles beginning on clock boundaries such as 00, 05, and 10. That convention is not universal. Some platforms offer custom or odd timeframes, such as seven or thirteen minutes, and some compute them from a different starting point.
Alignment changes the picture. Shift the start by one minute and the same price data produces a different set of highs, lows, and closes. A pattern that appears clean on one grid may be broken or absent on another, which is a useful reminder that candle shapes are partly an artifact of where the grid begins.
Odd timeframes add a subtler issue. Because they do not divide evenly into an hour, bars straddle hour boundaries, and the first bar after a session event can contain a mix of periods. Comparing readings across days is also harder, since the grid anchor may reset at midnight or at the session start, depending on the platform.
A scalper checking a rule can test whether it survives a one-minute shift of alignment. A setup that appears only on a single grid is more likely a product of bar construction than of market behavior.
Alignment changes the picture. Shift the start by one minute and the same price data produces a different set of highs, lows, and closes. A pattern that appears clean on one grid may be broken or absent on another, which is a useful reminder that candle shapes are partly an artifact of where the grid begins.
Odd timeframes add a subtler issue. Because they do not divide evenly into an hour, bars straddle hour boundaries, and the first bar after a session event can contain a mix of periods. Comparing readings across days is also harder, since the grid anchor may reset at midnight or at the session start, depending on the platform.
A scalper checking a rule can test whether it survives a one-minute shift of alignment. A setup that appears only on a single grid is more likely a product of bar construction than of market behavior.