Advertisement IC Markets

Killzone by volume burst instead of fixed clock

Real-time market analysis, live trade entries, order flow commentary, and daily setups for the London, New York, and Asian session overlaps.
Post Reply
LondonScalper
Posts: 965
Joined: Sat Sep 05, 2026 7:54 am

Killzone by volume burst instead of fixed clock

Post by LondonScalper »

I have been testing a different way to define my active window: wait for a volume burst instead of a fixed clock time.

The normal approach is a fixed killzone, say 07:00 to 10:00 London. My experiment keeps that outer window but adds a condition: I only look for continuation setups after tick volume on M1 exceeds roughly twice the average of the previous hour. Before the burst, I watch but do not trade.

Early results after about two months: fewer trades, slightly better average R, and fewer losses in the dead 07:00 to 07:45 stretch on quiet days. On busy days the burst comes almost immediately and nothing changes.

Some caveats. Tick volume on a retail feed is a rough proxy, not real volume. The threshold is arbitrary and I have not optimised it, because I do not want a curve-fitted number. And the sample is still small.

The fixed clock still runs everything else: news blackouts, my flatten time and the ticket limit. The burst only decides whether I look for continuation inside a window that was already allowed. I would not use it to extend trading outside my normal hours.

Has anyone tried something similar with real futures volume?
Recommended broker for automated trading & scalping IC Markets
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Killzone by volume burst instead of fixed clock

Post by Fairman »

LondonScalper wrote: Has anyone tried something similar with real futures volume?
The main thing futures volume gives you is size rather than update count, so a burst can't come from a feed simply sending more quotes. 6E or 6B volume during London is reasonable, though CME volume before about 07:00 London is thin enough that the previous-hour average itself is tiny, so a 2x threshold gets crossed easily early on. Comparing against the same time of day over the last 20 sessions instead of the previous hour would fix that. On the arbitrary threshold, you could check sensitivity without optimising: run 1.5x, 2x and 3x and see whether the results change direction or just degrade gradually. If small changes flip the result, the edge probably isn't in the burst.
It’s Fairman :geek:
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Killzone by volume burst instead of fixed clock

Post by Shadow Trader »

LondonScalper, waiting for a volume burst inside the outer killzone is something I tested for about six weeks last winter. Fewer tickets, slightly better average R, and far fewer losses in the dead stretch before 07:45 on quiet mornings.

Fairman's note about a same clock baseline across prior sessions is the fix I needed. Using only the previous hour made early London look busy simply because the base was tiny, so a 2x threshold fired almost every day by 07:10.

I now use a 20 session same clock average for the threshold and keep the burst as a gate only, never as a reason to trade past my flatten time. The fixed clock still owns news blackouts and the ticket limit.

Sensitivity across 1.5x, 2x and 3x did not flip my results. That gave me more confidence that the edge was not hiding in the exact multiplier.

I have been on the same clock baseline for two months now. Have you tried it yet, or are you still on the previous hour average?
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Killzone by volume burst instead of fixed clock

Post by Shadow Trader »

LondonScalper, since my last reply I logged when the burst actually arrived, and the timing turned out to be as useful as the gate itself. Over 38 sessions the 2x condition fired before 07:30 on 21 days, between 07:30 and 08:30 on 12, and never on 5.

Those five mornings without a burst were the interesting group. I took no continuation trades on them, and checking afterwards, four of the five were tight range days where my usual setup would have chopped back and forth.

The trap is scheduled data. A UK release at 07:00 or 09:30 prints a burst almost by definition, so I ignore any burst that starts within two minutes of a release time and wait for one that comes from the market itself.

I also let the gate expire. If no continuation setup appears within 45 minutes of the burst, the window closes again until another one, because a burst at 07:10 says little about conditions at 09:00.

Fairman's point about size versus quote count applies here too, since a burst built on quote flicker in a thin book is not the same event. Once your gate opens, does it stay open for the whole morning or do you put an expiry on it?
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Killzone by volume burst instead of fixed clock

Post by Shadow Trader »

A sudden surge in tick volume often accompanies a burst of activity. It's tempting to treat the spike as a signal: something is happening, jump in.

The problem is that tick volume doesn't say which direction. A spike can come from buying, selling, or just a flurry of quote updates from liquidity providers. It can also happen when a spread widens and quotes change rapidly, with no real trading behind it.

Combined with price action, it becomes more useful. A volume spike plus a break of a short-term high carries a different meaning than a spike during a sideways chop.

The volume level needed to count as a spike should be defined relative to normal levels for that hour, not as a fixed number.

Think of it like a crowd noise meter at a stadium. It tells that something is happening, not who's winning. Direction has to come from price itself, which is why the combination tends to outperform either piece alone.

Has a volume-based trigger added anything beyond price alone, and how was "unusual volume" defined in practice?
Post Reply