Advertisement IC Markets

Measured Moves: Using the Last Leg to Estimate the Next

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Measured Moves: Using the Last Leg to Estimate the Next

Post by Fairman »

Measured Moves: Using the Last Leg to Estimate the Next

A measured move assumes that markets often move in repeating legs of similar size. After an impulse, price pauses and then travels roughly the same distance again.
diagram.png
diagram.png (35.95 KiB) Viewed 205 times
The method is simple. Measure the first leg from its start to its end. Project the same distance from the end of the pause, in the same direction. The result is a rough target.

You see this logic inside other patterns. The flag target uses the pole's length. The double top target uses the height of the pattern. Triangles use the width. All are variations of measured moves.

It is an approximation, not a law. Markets sometimes stop short, extend beyond, or reverse entirely. A target gained from a measurement still needs a sanity check against structure: is there a major level in the way?

Its main strength is discipline. By projecting a target before entering, you can calculate risk-to-reward in advance and skip trades where the numbers do not work. If the stop is 30 pips and the measured target only 35, the trade may not be worth taking.

A common refinement is to take partial profit at the measured target and manage the remainder with a trailing stop.

Beware of asymmetry in different conditions. Volatility changes can make a second leg longer or shorter.

Practical step: find ten trend legs on your chart and check how often the second leg came within 20 percent of the first.
It’s Fairman :geek:
Recommended broker for automated trading & scalping IC Markets
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Measured Moves: Using the Last Leg to Estimate the Next

Post by Fairman »

A caveat: measured moves are rough guides. If the first leg was 80 pips, the second might be 60 or 110. I use it as a sanity check on whether a target is realistic, not as an exact number to place a limit order at. It's more useful when combined with the daily range. If the first leg took 80 pips and the pair has already moved most of its average daily range, the second leg might have to wait until tomorrow. Also check what's in the way. If there's a clear level halfway to the measured target, price may stall there first. In that case I'd take a partial at the level and leave the rest for the full measured move.
It’s Fairman :geek:
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Measured Moves: Using the Last Leg to Estimate the Next

Post by Fairman »

I like measured moves for deciding if a trade is worth it. If the projected target is only 1R away from a sensible stop, the trade probably isn't worth taking, even if the setup looks good. That filter has saved me from a lot of trades that looked great on structure but had nowhere to go. Work it out before entry: measure the projected leg, subtract the spread, and divide by your stop distance. If that comes out below about 1.5, skip it or find a tighter entry on a lower timeframe. It turns a vague feeling about potential into a number you can check in ten seconds.
It’s Fairman :geek:
FXS Prop Desk
Posts: 1693
Joined: Wed Oct 07, 2026 9:52 am

Re: Measured Moves: Using the Last Leg to Estimate the Next

Post by FXS Prop Desk »

In practice, measured move targets work better as zones than exact prices. Many traders take partial profit when price reaches about 80–90% of the projected distance, since moves often fall slightly short of the full projection, especially when the target coincides with an obvious level.

Measured moves also help with stop placement: if the projected target offers less than about twice the risk, the trade may not be worth taking.
FXS Official Team | The Idea Lab & Strategy
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Measured Moves: Using the Last Leg to Estimate the Next

Post by Shadow Trader »

The two thresholds here, 1.5 from the third post and about twice the risk from FXS Prop Desk, are both reasonable, and the gap comes down to win rate. At 1.5R the break even win rate is 40 percent, and at 2R it is about 33 percent, before costs.

So the right filter depends on how often the setup reaches its zone. A trader who hits the measured target half the time can live with 1.5, while one who gets there a third of the time needs the stricter rule.

The 80 to 90 percent idea changes the arithmetic too. Take an 80 pip first leg and a 25 pip stop under the pause: the full projection is 3.2R, but aiming for 85 percent of it, 68 pips, still gives 2.7R and probably fills far more often.

The method gets slippery after a deep pause. If the pullback gives back more than about 60 percent of the first leg, it is unclear whether you are projecting from a pause or from a brand new leg, and the target can shift by 30 pips on that choice.

Fairman, in that situation do you still project from the pullback low, or skip the measurement altogether? Skipping feels more honest, though it costs trades.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Measured Moves: Using the Last Leg to Estimate the Next

Post by Shadow Trader »

One distortion worth checking before projecting is whether a news candle sits inside the first leg. A single release can add a chunk of distance that the second leg has no reason to repeat, because the event that produced it is over.

Say the first leg is 80 pips, but 35 of them came in one candle on a CPI release. Projecting 80 from the pause assumes another surprise of the same size, while the part built by ordinary order flow was only 45 pips.

In that case I would treat 45 as the base and the full 80 as the stretch. With a 25 pip stop the base gives 1.8R, which clears the 1.5 filter from the third post but fails the 2R rule from FXS Prop Desk, so the two thresholds give different answers on the same trade.

The opposite case happens too. If the pause itself contains a news spike, say a sharp 20 pip drop that recovers within the hour, anchoring the projection at that low drags the target 20 pips below where the normal pullback would put it.

Fairman, do you strip release candles out of the measurement, or accept them as part of the leg? On the 15 minute it makes a real difference, while on the daily it probably washes out.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Measured Moves: Using the Last Leg to Estimate the Next

Post by Shadow Trader »

A signal that appears at 59 seconds into a one-minute bar might vanish at 60. The candle isn't closed until the last tick, and a final jump can change the whole picture.

Rules like "enter when the bar closes above the moving average" are tested on closed bars. In live trading, the trader sees the bar forming and has to decide whether to act before it closes. Acting early captures the move, but risks a false signal. Waiting means entering after the next bar opens, slightly later and often at a worse price.

The platforms' own tick-by-tick evaluation makes the difference visible. An EA coded for "on bar close" fires at the first tick of the new bar, which can be a few milliseconds or several seconds after the close.

The last second also behaves differently from other moments. Orders tied to the bar close, such as those from algorithms referencing a time-based benchmark, can cluster near the end of the bar, especially at the hour. That makes the closing ticks more volatile.

If the system relies on closed bars, it's worth checking how much the price moves between the signal bar's final tick and the first tick of the next. In a fast market, that gap can be a pip or two.

One way to examine this is to compare two versions of a rule: act on the first tick that satisfies the condition, or act only once the bar closes with the condition true. Run both across a few weeks of live or tick-replayed data, and compare the number of trades, the average entry slippage and the win rate.

Typical findings: the early version trades more and includes more false signals. The closed-bar version trades less and enters later. Which one wins depends on how quickly the move develops after the signal.

There's also a hybrid: act when the condition holds at, say, 50 seconds into the bar, after most of the noise has resolved, but before the close. This takes a bit of code but offers a compromise.

In any case, the rule needs to be tested in the form in which it will be traded. A backtest that assumes execution at the close, when the live version acts mid-bar, isn't testing the same strategy.

What typical gap occurs on your pair between the last tick of one bar and the first of the next?
Post Reply