Advertisement IC Markets

Trailing Stops, Three Methods Compared

Master exponential money management, position sizing calculators, strict daily stop-loss limits, and overcoming FOMO on micro-timeframes.
Post Reply
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Trailing Stops, Three Methods Compared

Post by Fairman »

Trailing Stops, Three Methods Compared

Once a trade moves in your favor, you face a choice: let it run or lock in profit. Trailing stops are a way to protect gains while staying in the trade. Here are three common methods.

1. Structure trailing.
Move your stop beneath each new swing low (for buys) or above each new swing high (for sells). It follows the trend's natural rhythm.

Pros: logical and flexible. Cons: needs patience, and can give back significant profit before the stop moves.

2. ATR trailing.
Place the stop at a multiple of ATR below the highest price reached (for buys), for example 2 times ATR.

Pros: adapts to volatility. Cons: may be too loose in quiet markets or too tight in volatile ones.

3. Moving average trailing.
Exit when price closes beyond a chosen moving average, such as the 20 period.

Pros: simple, objective. Cons: lagging, and can exit late.

How to choose:

- Test each method on your backtest data
- Compare average R, drawdown, and win rate
- Choose the one that fits your style and temperament

General tips:

- Don't trail too early, since normal pullbacks can stop you out
- Decide your method before entering
- Keep it consistent

A trailing stop isn't about squeezing every pip. It's about letting good trades breathe while protecting your capital.
It’s Fairman :geek:
Recommended broker for automated trading & scalping IC Markets
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Trailing Stops, Three Methods Compared

Post by Fairman »

A quick example of how the three methods differ on the same trade. On a long that runs from 1.0850 to 1.0920, a structure trail might sit under the last 15 minute higher low around 1.0895. An ATR trail at 2x ATR could be closer or further depending on how wild the session was. A fixed pip trail just follows blindly. Same trade, three very different exits.
It’s Fairman :geek:
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Trailing Stops, Three Methods Compared

Post by Fairman »

Common mistake with trailing: starting it too early. If you trail from the first few pips, normal pullbacks take you out of trades that had room to run. I don't start trailing until the trade has reached at least 1R or broken the next structure point. Before that, the original stop stays where it was, because that's where the idea is wrong. A good check is your journal's MAE on winning trades. If many winners pulled back 60 or 70 percent of the stop distance before working, an early trail would have cut most of them. The numbers usually make the case better than any rule of thumb.
It’s Fairman :geek:
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Trailing Stops, Three Methods Compared

Post by Fairman »

If you can't decide between them, try this on replay: take the same 30 trades and manage each one three times, once per method. Log the R result for each. It takes an afternoon, and you'll know which suits your setups instead of guessing. Write the trailing rule exactly before you start, for example 2x ATR on the 15 minute chart updated at each candle close, so you can't adjust it as you go. Breakout setups often do better with a looser trail, while range trades tend to work better with fixed targets. Thirty trades is a small sample, but it's enough to see big differences.
It’s Fairman :geek:
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Trailing Stops, Three Methods Compared

Post by Shadow Trader »

Fairman's replay idea gets more useful if you score giveback as well as final R. Giveback is how much of the best open profit a method hands back before exiting, and it says more about a trail than win rate.
img_12787_r1.png
img_12787_r1.png (117.35 KiB) Viewed 170 times
The chart runs one made up EURUSD long from 1.0850 with a 15 pip stop through all three methods. The 2x ATR trail, with ATR at 9 pips, sits 18 pips under the 1.0892 high and gets tagged on the dip to 1.0874 for 1.6R, while the structure trail under the higher low rides the move to 1.0920 and exits at 1.0895 for 3R.

The exit on a close below the 20 period average lands in between at 1.0889, about 2.6R. Same entry, same idea, and the result ranges from 1.6R to 3R purely on the exit rule.

The ATR loss here is not bad luck. Measuring from the highest wick means a sharp spike tightens the stop right before the most likely pullback, so trailing from the highest close instead often fixes most of it.

The reverse case matters too. On a grinding move with shallow pullbacks the structure trail lags badly and the ATR version will usually win, so one replay sample per setup type beats a single verdict.
FXS Prop Desk
Posts: 1691
Joined: Wed Oct 07, 2026 9:52 am

Re: Trailing Stops, Three Methods Compared

Post by FXS Prop Desk »

One more method worth comparing is the time-based trail, where the stop is moved to break-even or a set distance after a fixed number of candles. It is less precise than structure trailing but simpler to automate. Testing all three methods on the same set of entries in a backtest usually shows clear differences in average win and win rate.
FXS Official Team | The Idea Lab & Strategy
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Trailing Stops, Three Methods Compared

Post by Shadow Trader »

FXS Prop Desk's time based trail has a blind spot. Moving to breakeven after a fixed number of candles ignores where the trade is at that moment, so a long that is up 2 pips after six candles gets the same treatment as one that is up 12.

A tweak that helps is making the move conditional on progress. Something like breakeven after six 5 minute candles only if price has reached at least 0.7R, otherwise leave the original stop, keeps the simplicity while cutting most of the pointless scratches.

There is a mechanical point that catches people too. The built in trailing stop in MetaTrader 4 runs inside the terminal, so if the laptop sleeps or the connection drops, the trail stops moving and the last stop on the server is all that protects the trade.

Anyone relying on a trail while away from the desk should either run the terminal on a VPS or move the stop by hand at fixed checkpoints. Partial exits are another route, since half closed at 1.5R with the rest trailed loosely runs smoother than a tight trail on the full position.

Which of the three has held up best on gold for people here? The swings there leave the ATR version sitting a long way back.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Trailing Stops, Three Methods Compared

Post by Shadow Trader »

Most retail traders know market orders, limits and stops. A few lesser-used tools deserve attention.

One-cancels-the-other orders link a limit and a stop, so that when one fills, the other disappears. Very handy for bracket entries around a level. Not every platform supports them natively, but many brokers do.

Stop-limit orders turn into a limit when the stop level is touched, which prevents bad fills during spikes, at the cost of the possibility of not filling at all.

Trailing stops follow price by a fixed distance. They suit trending moves but get hit by noise in choppy markets.

Time-in-force settings control how long a pending order lives, such as good till cancelled, end of day or fill-or-kill.

Knowing the exact behaviour of each on a given platform is not exciting, but a misunderstanding costs real money. Testing each with a tiny size before relying on them is cheap insurance.

Which less common order types have proved useful here, and which caused trouble?
Post Reply