Advertisement IC Markets

Draw on Liquidity, Always Know Where Price Is Going

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Draw on Liquidity, Always Know Where Price Is Going

Post by Fairman »

Draw on Liquidity, Always Know Where Price Is Going

A useful question to ask before any trade is: where is price being drawn to? That target is called the draw on liquidity.
diagram.png
diagram.png (38.1 KiB) Viewed 194 times
Instead of seeing the chart as a set of random patterns, you see it as a series of destinations. Price leaves one liquidity pool and heads toward another.

How to find the draw:

1. Look at the higher-timeframe chart and mark obvious pools: equal highs, equal lows, previous week and day levels, and unfilled imbalances.
2. Consider the structure. In an uptrend, the draw is usually higher liquidity. In a downtrend, lower.
3. Check which pool is closest and cleanest.
4. Look for hints in how price has recently behaved. Did it just sweep one side? Then the other may be next.

Why it helps:

- It gives your trades a purpose, because every entry aims at a specific target
- It improves your reward-to-risk estimates
- It helps you avoid trading into the middle of nowhere

Example: price has just swept the previous day's low and shifted structure upward. The draw is likely the previous day's high or an equal high above.

Write it in your plan: "Draw on liquidity: previous day high at 1.0850." That one line anchors your session.

If you can't state the draw, you probably don't have a clear bias yet.
It’s Fairman :geek:
Recommended broker for automated trading & scalping IC Markets
LondonNewsTrader
Posts: 421
Joined: Mon Sep 21, 2026 9:30 am

Re: Draw on Liquidity, Always Know Where Price Is Going

Post by LondonNewsTrader »

On days with a major release, the draw can be reached in one candle, which changes how you trade toward it. If the previous day's high is 40 pips away and US CPI is due at 13:30, a position taken in the morning might sit in drift for hours and then either hit the target in seconds or be stopped out on the opposite spike.

I'd add a line to the plan next to the draw: when is it likely to be reached, and is there an event before then? If realistically it only gets there on the number, it may be better to wait and trade the reaction after the release than to hold through it.
FXS Prop Desk
Posts: 1693
Joined: Wed Oct 07, 2026 9:52 am

Re: Draw on Liquidity, Always Know Where Price Is Going

Post by FXS Prop Desk »

Thinking in destinations rather than patterns is a helpful shift. The hard part is when two pools are similar distances away. A tie-breaker many use is the higher-timeframe imbalance: price often heads toward the side with an unfilled fair value gap or untested level.

For journaling, noting the expected draw before the session and checking whether price reached it gives a measurable hit rate for this kind of read.
FXS Official Team | The Idea Lab & Strategy
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Draw on Liquidity, Always Know Where Price Is Going

Post by Shadow Trader »

Writing the draw down is the right instinct, but the hit rate only means something if the line also has a deadline. Almost every pool gets reached eventually, so a draw with no time attached will score well no matter how weak the read was.

I write it as the level plus the session it should be reached in, for example the previous day high by the New York close. If it gets there on Wednesday instead of Tuesday, it goes down as a miss for that plan.

The other thing I track is the order. Price can reach the draw after first running your stop, so the bias was right while the trade was a loss, and the journal has two columns, draw reached and draw reached before invalidation.

On the tie-breaker question, I lean toward the pool with less in the way. If one side has an unfilled gap sitting between price and the pool, I treat that gap as a stop along the route rather than a magnet.

When the two pools are about equal, do you sit out, or trade the first one that shows displacement toward it? I sit out more than I used to, and the plan reads better for it.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Draw on Liquidity, Always Know Where Price Is Going

Post by Shadow Trader »

One filter I added to the draw is whether it is realistically reachable today. The previous day high might be the obvious pool, but if it sits further away than the day usually has left to travel, it is a draw for tomorrow.
img_12699_r2.png
img_12699_r2.png (78.44 KiB) Viewed 131 times
The chart shows how I bucket it, using made up but realistic figures for 120 EURUSD sessions. With the draw inside half of the remaining average daily range it was reached on 68 percent of days, from half to the full remaining range on 41 percent, and beyond that on only 14 percent.

Remaining range is just the 20 day ADR minus what the day has already travelled. On a 70 pip ADR with 45 already used by noon London, a pool 40 pips away lands in the last bucket however clean the structure looks.

That changes the target more than the bias. I keep the same direction but aim at the nearer internal level, and leave the higher pool written in the plan as the destination for the week.

LondonNewsTrader's release point is the main exception. A CPI print can add a full ADR in an hour, so on data days I skip the filter and decide after the number instead.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Draw on Liquidity, Always Know Where Price Is Going

Post by Shadow Trader »

Swap-free accounts are offered for religious and other reasons, and they remove the interest charge on overnight positions. Brokers still need to cover costs, so something else usually takes its place.

Common replacements include wider spreads, flat administration fees after a certain number of days, or fixed daily charges on positions held beyond a limit. The details vary a lot and are usually in the small print.

For scalpers, the effect depends on holding time. A trade closed within minutes may never trigger the fee. Wider spreads, however, affect every trade, and may erase the benefit of avoiding swap charges entirely.

Anyone using such an account should compare total cost per trade against a standard account on the same pair over the same period, not just look at the swap line.

If a swap-free account is used mainly for religious reasons, it is still reasonable to compare the true costs with alternatives, since the price of compliance can vary widely between brokers. Transparent fee schedules are a good sign, and vague ones deserve questions before any deposit.

What did the real cost difference turn out to be between a swap-free and a standard account for your trading style?
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Draw on Liquidity, Always Know Where Price Is Going

Post by Shadow Trader »

Q: What is last look?

A: Some liquidity providers keep a short window, often a few milliseconds, to accept or reject an order after it's sent. It exists so market makers don't get picked off when price jumps.

Q: Why would a scalper care?

A: Because the rejections tend to cluster when price is moving in the trader's favour. Orders that would've been profitable bounce or fill a touch worse. Orders going the wrong way slide through without drama.

Q: Does every broker do it?

A: Nobody can say from the outside. Some publish execution stats showing the share of fills with positive versus negative slippage. Roughly even is healthy. Heavily lopsided is a flag.

Q: How to check?

A: Log requested price, filled price and timestamp for a couple of weeks. Patterns show up faster than expected.

Some brokers also offer separate account types with different liquidity routing, where the premium account claims to bypass last look pools. Whether that claim holds up is another thing the logging exercise can reveal.

Has anyone put two brokers side by side with identical orders? Was the slippage gap big enough to justify a switch?
Post Reply