Advertisement IC Markets

Price Action Basics, Pin Bars and Engulfing Candles

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Price Action Basics, Pin Bars and Engulfing Candles

Post by Fairman »

Price Action Basics, Pin Bars and Engulfing Candles

Indicators lag. Price action doesn't. Candlesticks show you what buyers and sellers did in real time, and two patterns are worth mastering first.
diagram.png
diagram.png (36.08 KiB) Viewed 268 times
The pin bar (rejection candle). A candle with a long wick and a small body. A long lower wick means sellers pushed price down but buyers rejected it strongly. A long upper wick shows the reverse.

The engulfing candle. A candle whose body completely covers the previous candle's body. A bullish engulfing after a decline shows buyers overpowering sellers. A bearish engulfing after a rally shows the opposite.

How to use them properly:

1. They matter only at key locations: support, resistance, order blocks, or after a liquidity sweep.
2. Check the trend. A bullish pin bar in a strong downtrend is weaker than one in a pullback within an uptrend.
3. Wait for the candle to close before acting.
4. Place your stop beyond the wick or the engulfing candle's extreme.
5. Target the next logical level.

Warning: a pin bar in the middle of nowhere is just a candle. Context is everything.

Many liquidity sweeps produce pin bars, so combining your SMC knowledge with candlestick reading makes both stronger.

Scroll back through your chart today and mark ten pin bars. See how many occurred at key levels, and what happened next.
It’s Fairman :geek:
Recommended broker for automated trading & scalping IC Markets
PropScalpDesk
Posts: 521
Joined: Sat Sep 19, 2026 7:50 pm

Re: Price Action Basics, Pin Bars and Engulfing Candles

Post by PropScalpDesk »

One quirk with engulfing candles in forex: intraday, each candle opens at or within a fraction of a pip of the previous close. So "body covers the previous body" mostly reduces to "opposite colour, bigger body", which happens constantly on M5. I only count an engulfing that also takes out the previous candle's wick.

For pin bars, fix a number before scrolling back or every wick starts to qualify. Mine is a wick of at least two thirds of the candle's range.

And when you mark the ten, include the ones at key levels that failed. Count only reactions and the exercise confirms the pattern whatever the truth is.
LondonNewsTrader
Posts: 421
Joined: Mon Sep 21, 2026 9:30 am

Re: Price Action Basics, Pin Bars and Engulfing Candles

Post by LondonNewsTrader »

Fairman wrote: Wait for the candle to close before acting.
Point 3 matters a lot on release days. The candle that contains a data print often looks like a perfect pin bar halfway through, with a long wick from the first spike, and then closes as a full-bodied candle in the direction of the second move. Entering before the close on a news bar is a common way to get caught on the wrong side.

The wick on those candles also isn't always real for your broker. Spikes in the first second can be wider on one feed than another, so a pin bar on one platform can be a much smaller wick on another. If the stop goes beyond the wick, the size of that wick affects the whole trade.

On quiet days your rules work well. I'd simply not read the release candle itself as a rejection or engulfing setup, and wait for the one that follows.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Price Action Basics, Pin Bars and Engulfing Candles

Post by Shadow Trader »

PropScalpDesk's two thirds rule is close to mine, but I add a size condition, because a perfect shape on a 3 pip candle means nothing on M5. I only count a pin whose full range is at least the 14 period ATR on that timeframe.

The stop placement in step 4 is where pin bars quietly get expensive. A 12 pip pin with the stop a pip past the wick risks about 13 pips plus spread from the close, and if the next level is 10 pips away the trade is upside down before it starts.

So on the bigger pins I place a limit at the midpoint of the wick instead of buying the close. In my notes that fills a bit under half the time, and the ones that fill carry roughly half the risk.

The ones that never come back are usually the strongest moves, so the limit does miss some good trades. I accept that, since chasing the close on a big pin was where most of my losses on this pattern came from.

On LondonNewsTrader's release point, I would also skip the first candle after the news bar if its range is still over twice the ATR. Does anyone else filter by size like this, or only by location?
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Price Action Basics, Pin Bars and Engulfing Candles

Post by Shadow Trader »

LondonNewsTrader's point that a wick depends on the feed has a cousin on the higher timeframes, which is where each candle starts and ends. A broker running GMT plus 2 server time draws its H4 and daily candles on different hours from one set to London time, so the same move can be a clean pin on one platform and two ordinary candles on another.

Sunday candles make it worse. A broker that prints a short Sunday bar changes the shape of Monday's daily candle, so a Monday pin on one platform may not exist at all on another.

On M5 this hardly matters, since five minute boundaries line up almost everywhere. It mostly catches people who take the H4 pin as the location and then drop to M5 for the entry.

For Fairman's ten pin exercise, PropScalpDesk's advice to include the failures needs a definition of failure written before scrolling. Mine is price trading back through the wick extreme before reaching 1R, which also tests whether the stop in step 4 was in the right place.

Fairman, do you treat a pin that forms on the sweep candle itself differently from one printing a candle later? The later one gives a tighter stop, but I am not sure it holds as well.
FXS Prop Desk
Posts: 1692
Joined: Wed Oct 07, 2026 9:52 am

Re: Price Action Basics, Pin Bars and Engulfing Candles

Post by FXS Prop Desk »

The engulfing pattern is much more useful when combined with location, just like the pin bar. One way to test this is to record every engulfing candle on a chosen pair and timeframe for a month and mark whether it formed at a pre-marked level. Comparing the outcomes of both groups usually shows how much the location matters.

Recording the timeframe of each pattern also helps compare results.
FXS Official Team | The Idea Lab & Strategy
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Price Action Basics, Pin Bars and Engulfing Candles

Post by Shadow Trader »

A range bar closes only when price has moved a fixed number of pips from the open, say 3. No time dimension at all. Quiet periods produce nothing, and fast ones produce a stream.

This gets rid of a lot of noise. A flat, drifting market doesn't print bars, so patterns and indicators only update when price actually moves.

The tradeoff is clarity versus information. Without a time axis, it's harder to see how long a move took, and the speed of a move is useful information for scalpers. Gaps also appear when price jumps, which can confuse tools that assume continuity.

Set the range too small and it becomes just another noisy chart. Set it too large and entries come late.

Some scalpers solve this by pairing range bars for entries with a time chart for context.

Backtesting adds a wrinkle. Range bars built from minute data approximate the real thing, but bars built from tick data capture the true path. Results can differ noticeably, so the source of the bars deserves a note in the test log.

Which range size has proven workable, and for what pair?
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Price Action Basics, Pin Bars and Engulfing Candles

Post by Fairman »

A release candle looking like a perfect pin bar halfway through is the trap I've fallen into most. The wick forms, the close isn't there yet, and I enter in the middle of the minute because it looks textbook. Then the second move comes and the bar closes as a full body in the opposite direction.

A hypothetical on GBPUSD M5 at 13:30: price spikes up 18 pips, falls back leaving a long upper wick, and I short 0.4 lots with a stop 4 pips above the wick high, so 22 pips from my entry, about 88 dollars. The bar then closes near its high after a second push. Taking the loss at the stop, that's 88 dollars plus slippage, on a setup that wasn't confirmed by a close.

Your note on feeds is one I'd not thought about. On one platform the first-second wick might be 24 pips and on another 15. If my stop sits beyond the wick, the sizing changes by that difference, which can be a third of the risk.

So now I don't read the release candle at all, as you suggest, and I wait for the next one to close. If it's an engulfing candle with the spread back under 1.5 pips, I'll consider it, with a stop beyond its extreme.

Do you check the same pair on a second feed or broker to see how the wick compares? And on quiet days, do you demand a close beyond the pin bar's body before entering?
It’s Fairman :geek:
Post Reply