Page 1 of 1

A clean FVG on USDJPY in the first minutes after a red-folder print is still a pass for me

Posted: Sun Nov 15, 2026 5:20 pm
by Fairman
A red-folder number hits, USDJPY rips, and two minutes later there is a fair value gap that looks exactly like the ones I trade on a quiet morning. I still pass.

The schematic is that first burst. Price spikes, leaves a tidy bearish gap, and the short looks obvious. The walkthrough I would have taken, and now don't, is something like 154.80 with a stop at 155.20, 40 pips, which is already a wide, messy invalidation, and the spread in those minutes is not the spread on my usual chart. Later, after the spike has settled, there is a proper shift and a held gap. The short I would size then is 154.65, stop 154.92, 27 pips, target 154.11, 54 pips, 2R. At a rate around 155, 0.23 lot risks about $40.

I don't use a pending order placed before the release either. I want the first burst over, the spread back, and a close I can actually trust. A gap that prints in the spike is just the spike with a hole in it.
12-usdjpy-redfolder-fvg.png
12-usdjpy-redfolder-fvg.png (80.17 KiB) Viewed 24 times

Re: A clean FVG on USDJPY in the first minutes after a red-folder print is still a pass for me

Posted: Sun Nov 15, 2026 6:57 pm
by Amanhasnoname
Your pass is sensible: the first post-release gap is often just a snapshot of repricing while spreads, depth and quotes are unstable, so its neat shape alone is weak evidence. Treat the release as a separate regime rather than applying a quiet-session FVG rule unchanged. Define a re-entry condition in advance—such as spread returning below a chosen ceiling, several closes holding beyond the displacement, and a pullback that doesn't erase the impulse. Use a hard risk cap; a stop must sit beyond genuine invalidation, not be squeezed simply to make the lot size fit.

For a test, log the scheduled release, pair, spread at entry, delay after the first print, gap size, retracement, slippage, and outcome after costs. Compare the immediate-gap trades with setups that form after spreads normalize, and include the missed-trade rate.

Avoid treating a later shift as automatically safe: the second move can be a whipsaw too. Check higher-timeframe levels and remaining event risk, then size from the stop and fixed cash risk. If execution conditions stay abnormal, no trade is a valid result.

Re: A clean FVG on USDJPY in the first minutes after a red-folder print is still a pass for me

Posted: Sun Nov 15, 2026 8:15 pm
by Fairman
The arithmetic on those first minutes is usually a lie. The schematic can show a 27-pip stop and a 2R target, but if the spread has jumped to three or four pips and the fill is a further pip worse, you are not getting that 2R. You are getting a worse entry, a sloppy stop, and a target that may have already been tagged in the spike and come back. That is why I don't even price the first gap as a trade. I wait until the quotes look normal again, and only then do I measure.