Page 1 of 1

I don't move the EURUSD stop to break-even until M5 closes beyond the first internal low

Posted: Sun Nov 15, 2026 2:12 pm
by Fairman
Moving the stop to break-even the moment a trade goes a few pips green is how I used to turn decent EURUSD ideas into a string of scratches and late stop-outs.

The walkthrough is a short at 1.09120, stop 1.09280, 16 pips, target 1.08800, 32 pips, 2R. A 0.25 lot risks $40 exactly. After the entry, price makes a first internal low at 1.09040, then retraces. If I have already jammed the stop to 1.09120, that retrace can tag 1.09125 and take me out, and then the 2R run happens without me. I have done that more times than I want to admit.

The change was to wait for an M5 close beyond that first internal low, under 1.09040 in this case, and only then move the stop up to around the entry. Until that close, the original 1.09280 stop stays where it is. I am still risking the $40 I sized. I would rather hold the planned risk until the structure actually confirms than protect a $6 open profit and lose the trade.
10-eurusd-be-internal.png
10-eurusd-be-internal.png (88.25 KiB) Viewed 25 times

Re: I don't move the EURUSD stop to break-even until M5 closes beyond the first internal low

Posted: Sun Nov 15, 2026 2:56 pm
by Amanhasnoname
Waiting for a candle close beyond the first internal low makes a lot of sense, because the first pullback after entry is usually just the market rebalancing rather than a sign the idea has failed. An early break-even stop sits right inside that normal retrace zone, so it gets hit far more often than the original structural stop ever would, and the trade is scratched just before it pays.

The reasoning behind the M5 close rule is that a close below the internal low shows sellers actually accepted lower prices, which shifts the structure in your favour. At that point a stop at entry is protected by a new swing high above it, not by hope. A useful refinement is to place the new stop just above that lower high rather than exactly at entry, so it respects structure instead of a round number.

The pitfall worth checking is how often price reaches about 1R and then reverses before any M5 close confirms. Tagging those trades in a journal for a month will show whether a partial close at 1R is worth adding for those cases.

Re: I don't move the EURUSD stop to break-even until M5 closes beyond the first internal low

Posted: Sun Nov 15, 2026 5:17 pm
by Fairman
A lot of 2R ideas die at plus one pip for this reason. The first pullback after a displacement often comes back close to the entry, sometimes a pip or two through it, and that is normal. If the stop is already at break-even, that pullback is a full stop-out, and the win I was so proud of on the way in never gets the chance to reach 1.08800. I would rather have a full loss at 1.09280, which I already accepted, than a string of break-even exits that make the journal look tidy and the week look flat.

Re: I don't move the EURUSD stop to break-even until M5 closes beyond the first internal low

Posted: Sun Nov 15, 2026 8:12 pm
by Fairman
When I do move the stop, I don't put it exactly on the fill. Spread and a tiny bit of noise sit around the entry, so I leave a pip, maybe a pip and a half, beyond 1.09120, toward the original stop. I am not trying to scratch to the exact tick. I am trying to take the 16-pip risk off the table once the internal low has been closed through. If I nail the stop to 1.09120 on the nose, I am back to getting tagged by the same retrace, just a candle later.