Page 1 of 1

I enter at 50% of the displacement leg, not at the first tick of the gold FVG

Posted: Sun Nov 15, 2026 11:19 am
by Fairman
I don't try to catch the first tick of a gold FVG. The entry I actually want is halfway back through the displacement leg that created the gap.

On the schematic, gold drops from 4,012 to 3,976, a $36 leg, and leaves a bearish gap around 4,002 to 4,008. The first tick of that gap would be a short up near 4,008 or 4,002. The 50% of the leg is 3,994, and that is the price I use. The stop sits at 4,014, a little beyond the start of the displacement, $20 from the entry. A 0.02 lot, 2 ounces, risks $40. The target at 3,954 is another $40, a clean 2R.

If price never retraces to 3,994, I don't chase the first tag of the gap just so I'm in. I missed it. The 50% entry is further into the move, so the stop is wider than a gap-only stop, and the lot has to stay small. That is the trade-off I accept, because the first tick of a gold gap gets faded a lot, and I was tired of being the fade.
08-gold-50pct-leg.png
08-gold-50pct-leg.png (98.7 KiB) Viewed 29 times

Re: I enter at 50% of the displacement leg, not at the first tick of the gold FVG

Posted: Sun Nov 15, 2026 12:56 pm
by Amanhasnoname
Entering at the midpoint of the displacement leg is a sensible way to avoid being the first order sitting in a gap that gets faded. The reasoning is that the gap edge is where everybody places the same limit order, while the halfway level of the leg is an equilibrium point where the move has given back some of its energy but not its structure. On gold the thing to check is how often price actually reaches that level before the idea dies, because a deep entry only works if the retrace happens often enough.

Worth testing is a clear invalidation rule for the pullback. If price trades back through the origin of the leg before it tags the midpoint, the setup is simply gone, and a resting order should be cancelled instead of left on the chart. Also compare a fixed 50 percent against a band, say 40 to 62 percent, since gold overshoots round levels often and exact-tick entries get missed by a few cents.

The main pitfall is the wider stop. Size from the stop distance, not from a habitual lot, and check that the spread plus slippage is small against that distance during news hours. Log fill rate, average reward to risk, and missed trades separately, because the missed ones are part of the cost.

Re: I enter at 50% of the displacement leg, not at the first tick of the gold FVG

Posted: Sun Nov 15, 2026 2:09 pm
by Fairman
If the retrace never reaches 3,994, I let it go. I used to 'at least take the FVG' so I wouldn't watch the drop without a position. That is how I got shorts off at 4,006 with a tight stop that was still inside the displacement, and then the leg did one more push up through the gap and took me out before it ran. The rule is the 50% or nothing, not the 50% or the first tick as a backup. Missing a $40 move on gold is cheaper than a $40 stop on an entry I didn't want.

Re: I enter at 50% of the displacement leg, not at the first tick of the gold FVG

Posted: Sun Nov 15, 2026 5:14 pm
by Fairman
People mix up 50% of the displacement leg with 50% of the FVG itself. They are not the same price. The gap on the schematic is 4,002 to 4,008, so the midpoint of the gap is 4,005. The midpoint of the 4,012-3,976 leg is 3,994, well below the gap. I am using the leg, not the imbalance. The gap tells me the move was impulsive. The entry is the equilibrium of that impulse. If I only retrace to the gap, I am still in the premium of the leg, and that is a more aggressive short than the one I want to size.

Re: I enter at 50% of the displacement leg, not at the first tick of the gold FVG

Posted: Sun Nov 15, 2026 8:09 pm
by Fairman
Because the stop has to live beyond 4,012, the size comes down. A gap-only short at 4,002 with a stop at 4,014 is $12 of room and would allow a 0.03 lot for $36 of risk. My 3,994 entry with the same 4,014 stop is $20 of room, so 0.02 lot and $40. I am paying for a better location with a smaller lot. I don't then add 0.01 later at the gap to 'get back' to 0.03. One entry, at the 50%, at the size the wider stop allows.