What counts as a clean retest on the one-minute chart?
Posted: Sat Nov 14, 2026 4:16 pm
"Wait for the retest" is one of the most common pieces of advice for breakout trading, and it's also one of the vaguest. On a higher timeframe a retest is fairly easy to see. On the one-minute chart almost every level gets touched, poked through and reclaimed several times, so what actually qualifies?
Some definitions people use, each with its own trade-offs:
Touch and reject. Price comes back to the broken level, prints a candle that touches it and closes back on the breakout side. Simple, but on one-minute charts this happens constantly, including on breakouts that fail ten minutes later.
Close-based. Price can wick through the level, but no candle may close beyond it. This filters out a lot of noise, but the entry tends to be later and the stop wider.
Time-based. The retest has to happen within a set number of candles after the break, for example 15 or 20. Late retests often mean the breakout has lost momentum and price is just drifting back.
Structure-based. After touching the level, price needs to make a small higher low (in a long setup) before entering. This is slower again but gives a clear invalidation point.
Probably the most useful thing is to pick one definition and write it down precisely enough that two different people would mark the same candles on the same chart. If the definition can't be written that clearly, it's very hard to test, and it's very easy to see a "clean retest" whenever you want to be in a trade.
Which definition do people here actually use, and does it change between pairs?
Some definitions people use, each with its own trade-offs:
Touch and reject. Price comes back to the broken level, prints a candle that touches it and closes back on the breakout side. Simple, but on one-minute charts this happens constantly, including on breakouts that fail ten minutes later.
Close-based. Price can wick through the level, but no candle may close beyond it. This filters out a lot of noise, but the entry tends to be later and the stop wider.
Time-based. The retest has to happen within a set number of candles after the break, for example 15 or 20. Late retests often mean the breakout has lost momentum and price is just drifting back.
Structure-based. After touching the level, price needs to make a small higher low (in a long setup) before entering. This is slower again but gives a clear invalidation point.
Probably the most useful thing is to pick one definition and write it down precisely enough that two different people would mark the same candles on the same chart. If the definition can't be written that clearly, it's very hard to test, and it's very easy to see a "clean retest" whenever you want to be in a trade.
Which definition do people here actually use, and does it change between pairs?