Page 1 of 1

What should a scalper do when the Asian range is unusually wide?

Posted: Sat Nov 14, 2026 9:42 am
by Shadow Trader
Most London-open approaches quietly assume the Asian session was a tidy, narrow box. Mark the high and low, wait for London to take one side, trade the break or the fake-out. That works reasonably when the range is 20-30 pips on EURUSD. It gets a lot less clear when Asia has already travelled 60 or 70 pips because of an RBA decision, Chinese data or a weekend gap that kept filling.

A few things change when the range is wide:

The obvious breakout levels are far away, so a "break of the Asian high" might mean buying after the day's average range is already half used up.
The middle of the range often matters more than its edges, because London frequently spends its first hour working out whether Asia's move was real.
Stops sized for a normal day are too tight for the swings inside a wide range, and stops sized for the wide range make the reward side look poor.

One way to handle it is to measure the Asian range against something like the 20-day average daily range before London opens, and have two playbooks. Normal range: the usual break and retest ideas. Wide range: either stand aside for the first 30-60 minutes, or only take trades back toward the middle of the range once London shows it doesn't want to extend.

It's also worth checking how often a wide Asian session is followed by a quiet London on your pairs. That's easy to pull from historical data and it answers the question better than any opinion.

How do others here treat an Asian session that has already done most of the day's work? Do you adjust, or skip the open entirely?