forex-scalping.com

Why Your Order Block Failed, A Troubleshooting Guide

Order blocks fail often. That isn't a flaw in the concept, it's a reminder that no zone is guaranteed. But repeated failures often come from avoidable mistakes. Use this troubleshooting list. 1. No liquidity sweep. Did price take liquidity before the move that created the block? Blocks without that context are weaker.

2. Weak displacement. Was the move away from the block strong, with large candles and imbalance? A slow drift isn't convincing.

3. Wrong location. Was the block in premium for a buy, or discount for a sell? Location matters.

4. Against the higher-timeframe bias. A bullish block inside a strong bearish trend is a risky bet.

5. Already mitigated. If price has returned to the zone before, it may be used up.

6. Entering without confirmation. Placing a blind limit order at the edge ignores what price does when it arrives.

7. Poor stop placement. A stop inside the zone is often hit by normal wicks.

8. Bad timing. Trading during dead hours or right before news.

9. Over-marking. Too many blocks on the chart means you're guessing.

10. Emotional entry. Boredom, FOMO, or revenge.

How to use the list: after each failed block trade, go through it and tick which items applied. After 20 trades, you'll know your most frequent cause.

Fix that one first, and your results can improve noticeably.

Turning this list into journal columns works better than running through it from memory after a loss. Tick the boxes when you take the trade, not after it fails, so you can't rationalise which applied.

It also helps to split it. Items 1 to 5 and 9 are about the zone and can be checked before price arrives; 6, 7, 8 and 10 are execution. If most failures sit in the first group, fix the marking. If they sit in the second, the zones may be fine and the entries leak.

Item 5 needs a definition. I count a touch of the near edge as mitigated, which removed a lot of second-touch trades that used to look good to me.

A useful checklist, and point 1 on the missing sweep is probably the most common cause. One item worth adding: the block's location relative to higher-timeframe levels. A 5M bullish block that sits just under a 4H bearish block or a daily resistance is often run straight over, however clean it looks on the lower chart.

Checking the higher-timeframe map before marking lower-timeframe blocks prevents many of these failures. It also helps to note in the journal which item on the list explained each failed block. After 30 or 40 failures, one or two reasons usually dominate.

One problem with ticking the list only after losses is that you never see how often the same boxes apply to winners. If no sweep shows up on 60 percent of failed blocks but also on 55 percent of the ones that worked, it is not your cause, it is just common.

So I fill in the columns PropScalpDesk described on every block trade, win or lose, and compare the two rates after 40 or so. The items worth fixing are the ones with a clear gap, which for me turned out to be items 5 and 8 rather than the sweep.

On item 8, the dead hour that hurt me most was the rollover around 22:00 London. Spreads on some pairs widen to 2 or 3 pips for a few minutes, and a block that would have held gets tagged by the spread rather than by price.

Item 7 also needs a number rather than a feeling. I place the stop beyond the block by the average spread for that hour plus one pip, so it sits wider at night than at the London open.

Has anyone found a cause that is not on the list at all? Mine was entering blocks that formed during a news spike, where the displacement looked strong but the wick barely traded.