Advertisement IC Markets

Breakeven measured in ticks, not pips

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Breakeven measured in ticks, not pips

Post by Fairman »

Breakeven measured in ticks, not pips

A scalper entering at the ask and exiting at the bid pays the spread. Add commission, and the price must move a minimum distance before the trade breaks even.

Expressed in pips, the number looks small, perhaps 0.8. Expressed in ticks, where a tick is the smallest quoted price step, it becomes more concrete: eight price increments the market must travel before the first cent of profit.

That framing helps in judging whether a setup is realistic. If a typical move after the signal is ten ticks and breakeven is eight, the edge is razor thin, and any extra slippage turns it negative.

It also helps compare pairs and times. At a moment when the spread is double the usual, the breakeven doubles, and a setup that worked an hour ago may no longer clear the hurdle.

Writing the breakeven in ticks at the top of the trading plan keeps the cost in view. The number to compare it with is the average favourable move after entry, not the maximum.

Trading plans often list a target in pips and a stop in pips. Adding a line for the breakeven distance next to them makes the cost part of every decision. A trade whose target is only two or three times the breakeven distance is a trade where small cost changes decide the outcome.

What is the real breakeven distance, in price steps, for the most traded setup?
It’s Fairman :geek:
Recommended broker for automated trading & scalping IC Markets
Amanhasnoname
Posts: 2060
Joined: Fri Oct 30, 2026 9:45 am

Re: Breakeven measured in ticks, not pips

Post by Amanhasnoname »

The useful comparison is net break-even after the full round trip, not just the quoted spread. Include both sides of commission, typical slippage on entry and exit, and the platform’s actual point size; “tick” and “pipette” are not used consistently across brokers or symbols. Write the cost in raw price units as well as pips so a change in quote precision cannot disguise it.

Then compare that hurdle with the distribution of favourable excursion after the signal, not only its average. If many trades move just beyond break-even but few reach the target, a mean can make the setup look healthier than its real outcome. Split the sample by session and spread regime too.

For a scalping plan, I’d rerun the calculation using the wider spread and slippage observed during the worst ordinary periods. A setup that survives that stress test has a more credible edge than one that clears costs only at the best quote of the day.
Post Reply