Advertisement IC Markets

Dealing Ranges, Mapping the Playing Field

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Dealing Ranges, Mapping the Playing Field

Post by Fairman »

Dealing Ranges, Mapping the Playing Field

Price spends most of its time moving between two meaningful points. The area between them is often called the dealing range. Identifying it early gives you structure, boundaries, and context.
diagram.png
diagram.png (39.61 KiB) Viewed 250 times
How to mark a dealing range:

1. Find a significant swing high and swing low that define the recent movement.
2. Draw the range between them, and mark the 50% midpoint.
3. Note where price currently sits: premium, discount, or near equilibrium.

How to use it:

- In a bullish context, look for buys in the lower half of the range and avoid buying near the top.
- In a bearish context, look for sells in the upper half and avoid selling near the bottom.
- Treat a break and close beyond the range edge as a possible new dealing range forming.

Nested ranges: smaller ranges exist inside larger ones. A 15-minute range can sit inside a 1-hour range, which sits inside a 4-hour range. Align them when possible. The best setups often occur when discount on the lower timeframe aligns with discount on the higher one.

Benefits:

- It prevents chasing
- It clarifies where risk-to-reward is favorable
- It makes your targets more logical

Common mistake: redrawing the range constantly. Pick it based on clear structure and update only when structure changes.

A clean range on the chart equals a clearer mind during the session.
It’s Fairman :geek:
Recommended broker for automated trading & scalping IC Markets
LondonNewsTrader
Posts: 421
Joined: Mon Sep 21, 2026 9:30 am

Re: Dealing Ranges, Mapping the Playing Field

Post by LondonNewsTrader »

On redrawing the range: release days are the main temptation. A data spike can extend the range by 30 or 40 pips in a minute and then retrace the whole thing within the hour. I'd wait for a session close beyond the old boundary before redrawing, otherwise the premium and discount zones end up anchored to a candle most participants have already dismissed.
FXS Prop Desk
Posts: 1693
Joined: Wed Oct 07, 2026 9:52 am

Re: Dealing Ranges, Mapping the Playing Field

Post by FXS Prop Desk »

The 50% midpoint gives a clear premium/discount frame. A question that often comes up: when does a new dealing range replace the old one? A common rule is that the range is redefined when price closes beyond one end and forms a new swing point, which then becomes the new boundary.

Writing that rule down helps, because otherwise traders tend to redraw ranges until price "fits", which removes the objectivity.
FXS Official Team | The Idea Lab & Strategy
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Dealing Ranges, Mapping the Playing Field

Post by Shadow Trader »

The hard part for me is step 1, choosing which swing high and low define the range. Two traders looking at the same 1H candles will often pick different pairs of swings, and their midpoints can sit 15 pips apart on EURUSD.

My rule is that a swing only counts if it caused a move of at least half a daily ATR away from it. That removes most of the small internal swings and leaves one or two candidate ranges per timeframe.

I also treat the midpoint as a band rather than a line. Anything between 45 and 55 percent is equilibrium for me, and I take no new entries there in either direction.

On the nested ranges point, the conflict case is the one worth planning for. When price is in discount on the 15 minute range but in premium on the 4 hour one, I side with the higher timeframe and wait.

How often do people find the higher range breaks while they wait? In my experience that is when the new dealing range gets drawn too early, right after the first close outside.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Dealing Ranges, Mapping the Playing Field

Post by Shadow Trader »

The lower half rule is generous once you put numbers on it. On a 60 pip range with the stop 5 pips under the low, a buy at the 25 percent level risks 20 pips to make 45, while a buy at 45 percent risks 32 to make 33.

Both are technically in discount, but only one is a trade I want. So I split the range into quarters and only take entries in the outer quarter, which on that example means within 15 pips of the low.

The cost is frequency. A lot of bullish days pull back to 35 or 40 percent and then go, and those days simply get missed under this rule.

I accept that because the misses are cheap and the shallow entries were expensive. When I reviewed my shallow discount buys, the losers were nearly all full stops while the winners often stalled before the range high, which is the worst mix.

On FXS Prop Desk's redefinition rule, do you keep trading the old range while the new swing point forms? I have had several sessions where price closed outside, came back in, and the old midpoint worked fine for the rest of the day.
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Dealing Ranges, Mapping the Playing Field

Post by Shadow Trader »

In MT4, the slippage or "deviation" field in the order window sets the maximum difference in price between the requested and the executed price. A value of 3 points allows a fill up to 3 points away. If the market has moved more, the order is rejected or requoted, depending on the execution mode.

Set to 0, the order is likely to be rejected whenever the price changes at all. Set high, say 50, nearly every order fills, with a possible bad price.

Many EAs have a slippage parameter, and the default is often a high number. The trader may not realize that the system accepts fills far from the signal.

For market execution accounts, the setting is sometimes ignored, since the broker fills at the best available price regardless. The field remains in the platform, giving the impression of control, but doesn't constrain anything.

A test can show whether it works: place orders with deviation 0 during a fast market on a demo or small live account and see if they fill with slippage. If fills still occur at different prices, the setting isn't enforced.

The setting is a tool for trading off fill rate against price quality. The right value depends on the target size, and for a 2 pip target, 3 pips of allowed slippage makes no sense.

It's also worth knowing whether the setting applies to pending orders when they trigger. In many setups the deviation on a pending order is fixed at the time of placing, so an order set weeks earlier may carry an old tolerance. Reviewing the order's properties in the terminal confirms the actual value in force.

What deviation is used, and is it actually respected by the broker?
Post Reply