Advertisement IC Markets

Three push exhaustion on M1 at session extremes, small trades with a tight idea

Discuss 1-minute to 15-minute price action setups, fading intraday momentum, key support/resistance zones, and proven short-term trading methodologies.
Post Reply
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Three push exhaustion on M1 at session extremes, small trades with a tight idea

Post by Fairman »

Three push exhaustion on M1 at session extremes, small trades with a tight idea

this is a pure scalp and I keep it small. When price is pushing up into a session high on M1 and I count three distinct pushes, each one with a higher high but weaker candles, I start watching for an exhaustion short. Weaker means smaller bodies, longer upper wicks, less follow through.
diagram.png
diagram.png (39.47 KiB) Viewed 197 times
I don't short the third high. I wait until price breaks the low of the last small pullback, then take the retest of that low from below. Stop goes above the third push high. Target is the start of the third push, which is usually only a handful of pips, so spread really matters and I only do it on majors when the spread is normal.

It works best at the end of a London move, say from about 10:00 GMT, or in a quiet part of NY. It fails when the third push is actually the start of a breakout, which tends to happen on news days. If the candles are getting bigger instead of smaller, it's not exhaustion, it's acceleration, and I stay out.
It’s Fairman :geek:
Recommended broker for automated trading & scalping IC Markets
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Three push exhaustion on M1 at session extremes, small trades with a tight idea

Post by Fairman »

Since the target is so small on this one, I am strict about the spread. If EURUSD is showing more than its usual spread when the setup forms, I skip it. Same with GBPUSD. The whole trade is a few pips, so one extra pip of spread can wipe out a big chunk of the reward. I also only use limit orders for the entry on the retest so I am not paying extra slippage on top. It is a small trade and it only makes sense when costs are low.
It’s Fairman :geek:
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Three push exhaustion on M1 at session extremes, small trades with a tight idea

Post by Fairman »

How I count pushes, because a few people found this confusing. A push is a move up that makes a new high, followed by a pullback of at least a few candles that does not make a lower low than the previous pullback. If price is just grinding up candle after candle with no real pullbacks, it is one push no matter how long it goes on. I am looking for three clear legs I could point at on the chart, not a count I have to squint to find.
It’s Fairman :geek:
Fairman
Posts: 6955
Joined: Tue Jul 21, 2026 7:11 am
Location: Abuja

Re: Three push exhaustion on M1 at session extremes, small trades with a tight idea

Post by Fairman »

One thing I watch alongside the candles is what the M5 chart is doing. If M5 is still printing strong bullish candles while M1 shows three pushes, I usually leave it, because M1 exhaustion inside an M5 trend is just a pause. The better ones happen when M5 has already started to slow down with smaller bodies and wicks on top. Then the M1 pattern is basically the final part of a move that was running out of steam anyway.
It’s Fairman :geek:
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Three push exhaustion on M1 at session extremes, small trades with a tight idea

Post by Shadow Trader »

The cost point is easy to underrate on this one because the target usually sits closer than the stop. Say the third push starts at 1.0912 and tops at 1.0924, the last pullback low is 1.0918, and the short goes in on the retest of 1.0918 with the stop 2 pips above the high at 1.0926.

That risks 8 pips to make 6, so before costs the trade needs to win about 57 percent of the time. Add a 1 pip spread and the win shrinks to 5 while the loss grows to 9, which moves break even to about 64 percent.

Needing nearly two wins in three leaves very little room. That is why skipping it on a wider than normal spread, as described above, is not optional.

One fix is to split the exit. Half comes off at the start of the third push and the rest aims for the low of the second push.

With the second push low at 1.0906, the runner would make 12 pips gross, so when both targets are reached the average win before costs becomes 9 pips against the same 8 pip risk. Has anyone tried that split, or does the move usually stall at the start of the third push?
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Three push exhaustion on M1 at session extremes, small trades with a tight idea

Post by Shadow Trader »

One way to take the guesswork out of weaker candles is to measure each push in pips, from its pullback low to its new high. Exhaustion usually shows up as legs that shrink, while acceleration shows up as legs that grow, whatever the single candles look like.

Say the three legs on M1 measure 9, 6 and 4 pips. Each one is roughly two thirds of the one before, which is the kind of fade this setup is built on.

A simple filter is that the third leg must be no more than 80 percent of the second. With a 6 pip second leg, a third leg of 5 pips or more fails it, and those are often the ones that turn into the breakout described above.

The second check is time once the short is on. With the target only a few pips away, a trade that has not moved within five or six M1 candles is usually a sign the buyers have not finished, and closing it near entry costs far less than waiting for the stop.
FXS HongKong Scalper
Posts: 548
Joined: Sat Oct 24, 2026 10:15 pm

Re: Three push exhaustion on M1 at session extremes, small trades with a tight idea

Post by FXS HongKong Scalper »

The M5 slowdown filter makes a lot of sense. Another quick check is the distance of the third push compared with the first two. If each push is shorter, the move is losing energy and the pattern is cleaner. If the third push is the longest, it is more likely a continuation with a pause than real exhaustion, even if M1 shows three pushes. It is also worth noting where in the session the extreme forms. A three push top near the session high in a quiet window often holds better than one forming during a news release.
FXS Official Team | Hong Kong Session Desk
Shadow Trader
Posts: 5594
Joined: Wed Sep 09, 2026 5:19 pm

Re: Three push exhaustion on M1 at session extremes, small trades with a tight idea

Post by Shadow Trader »

Every three years, the Bank for International Settlements publishes a survey of global foreign exchange turnover. The headline figure is staggering, several trillion dollars per day, but the composition is more interesting for traders.

The dollar sits on one side of close to nine out of ten trades. The euro, yen and sterling follow. A large portion of turnover comes from FX swaps, not spot trades, and these are mostly used for funding, not speculation.

Retail trading makes up a small slice, a few percent of the total. Dealers, hedge funds, asset managers and corporates account for most of the rest.

That perspective matters. Price is driven largely by participants with motives unrelated to a scalper's chart: hedging, funding, portfolio rebalancing.

A retail trader competes with, and trades against, flows that do not care about technical levels.

Understanding who is on the other side of a trade helps explain why some patterns fail and why edges are small.

Does knowing the market's composition change how setups are judged here?
Post Reply